LG F1695RDH Service Manual ▷ View online
57
1 Disassemble the lower cover assembly.
2 Take out the main PCB assembly from the
front of the washer.
3 Remove 3 clamps from the each hose.
4 Remove 3 screws from the base cabinet.
5 Disconnect the wire of pump.
Take out the drain pump assembly in the
direction displayed in the fig.
direction displayed in the fig.
1 Loosen the nut.
2 Remove washing heater by pulling out.
2 Remove washing heater by pulling out.
When assembling the washing heater, insert
the heater to heater clip on the bottom of tub
and check the position of wire color.
the heater to heater clip on the bottom of tub
and check the position of wire color.
DRAIN PUMP ASSEMBLY
HEATER
< Heater for Washing>
• Rating : 230V 2000W
• Resistant : 24.5~28.5Ω
• Rating : 230V 2000W
• Resistant : 24.5~28.5Ω
CAUTION
Clamp1
Clamp2
Clamp3
58
1 Remove washing heater.
2 Remove the foreign object(wire,coin,etc) by
2 Remove the foreign object(wire,coin,etc) by
inserting long bar in the hole.
WHEN FOREIGN OBJECT STUCK BETWEEN DRUM AND TUB
1 Disassemble lower cover assembly.
2 Disassemble MAIN PWB ASSEMBLY
3 Disconnect the wiring connector.
4 Unfasten the screw from the part displayed in
the fig and then turn the safety switch assembly
to disassemble.
to disassemble.
SAFETY SWITCH ASSEMBLY
2
1
59
REAR COVER ASSEMBLY
2 Remove screws that fasten the rear cover
to the side cabinets.
1
3 Remove screws that fasten the rear cover
to the base cabinet.
4 Remove screws that fasten the rear cover
to the tub outer.
5 Remove screws that fasten the drain hose
holders to the rear cover.
6 Remove screws that fasten the inlet valve
assembly and the generator assembly to
the rear cover.
the rear cover.
7 Remove 2 earth screws from rear cover.
8 Disassemble 3 holder hooks for fixing
harness.
9 Disassemble the red connector assembled
noise filter.
10 Pull out drain hose from the rear cover.
11 Disassemble back cover.
Disassemble top plate assembly.
Needed tool : (+) Electric driver
60
REAR GASKET
Disassemble top plate assembly.
Needed tools :12,13 mm wrench, (
) Clamp Jig, Cable Tie, (+) Electric driver
Disassemble rear cover.
Remove large and small gasket clamps using
gasket clamp jig.
gasket clamp jig.
Unfasten the nut that fastens the rear
suspension to the base.
suspension to the base.
Unfasten the bolt that fastens the rear
suspension to the bearing housing.
suspension to the bearing housing.
Disassemble rear suspension.
Remove 8 screws from both weights.
Disassemble rear gasket.
1
2
3
4
5
6
7
8
Click on the first or last page to see other F1695RDH service manuals if exist.