LG DWM1300 Service Manual ▷ View online
24
NO
YES
YES
YES
NO
NO
NO
YES
(1)
3
1
2
Spin
Temp.
Spin
Option
S P I N T R O U B L E
Check the sensor
(Pressure) or hose
(Sensor).
If the problem is on the
sensor or the hose, replace
the sensor or the hose.
(Pressure) or hose
(Sensor).
If the problem is on the
sensor or the hose, replace
the sensor or the hose.
Normal.
Correct the connector.
Replace the motor
assembly.
(4681FR1241C)
assembly.
(4681FR1241C)
Check on the spinning, is the frequency of the
water level 248 or more. The frequency can be
checked by pressing the [Option] and [Spin] buttons at
the same time on the program.
water level 248 or more. The frequency can be
checked by pressing the [Option] and [Spin] buttons at
the same time on the program.
When pressing [Spin], [Temp.] and POWER buttons
at the same time after power off, press the
START/PAUSE button 2 times, is the drum spinning
at low speed?
at the same time after power off, press the
START/PAUSE button 2 times, is the drum spinning
at low speed?
Is it disconnected, or disassembled?
~Red : 3-pin (1)₩
Check the motor connector, is the resistance of
the terminal same as the figure?
MOTOR TERMINAL
Resistance of terminal:
①~② / ②~③ / ③~① : About 6.5Ω
Replace the PWB assembly (Main).
① ② ③
25
Be sure to unplug the machine out of the outlet before disassembling and repairing the parts.
10. DISASSEMBLY INSTRUCTIONS
①
① Unscrew 2 screws on the back of the top plate
assembly.
②
② Pull the top plate backward and upward as shown.
①
① Disconnect the PWB assembly (Display) connector.
②
② Pull out the drawer and unscrew 3 screws.
③
③ Push 2 upper hooks down and pull the control panel.
①
① Pull out the Rotary (Dial) knob.
②
② Disconnect the PWB assembly (Display) from the
control panel by unscrewing 7 screw.
HOOK
PANEL ASSEMBLY (CONTROL)
PWB ASSEMBLY
(DISPLAY)
(DISPLAY)
CONTROL PANEL
PLATE ASSEMBLY (TOP)
26
①
① Disassemble the top plate assembly.
②
② Pull out the drawer to arrow direction.
③
③
③ Unscrew 3 screws.
①
① The hose clamps and the hose are disassembled.
②
② The ventilation bellows and the water inlet bellows
are disassembled on the tub.
DRAWER
DISPENSER ASSEMBLY
DISPENSER ASSEMBLY
27
①
① Disconnect the wiring receptacle.
②
②
② Unscrew 2 screws from the back.
※When reconnecting the connector.
■ Open the lower cover plate by using coin and pull out the
lower cover in the arrow direction after a screw is
unscrewed.
unscrewed.
①
① Remove the back cover.
②
② Unscrew 2 screws.
③
③
③ Pull the PWB assembly (Main) as shown.
1
2
3
INLET VALVE
PWB ASSEMBLY (MAIN)
LOWER COVER
VALVE #1 (MAIN)
Whited/Black-Black
VALVE #2 (PRE)
Gray/ White - Black
VALVE #3 (HOT)
Blue/Red - Black
Click on the first or last page to see other DWM1300 service manuals if exist.