LG 40002 Service Manual ▷ View online
28
Disassemble the clamp assembly.
Unscrew the 2 screws from cabinet cover.
Open the filter cover and unscrew 1 screw.
Remove the lower cover.
Unscrew all the screws from upper and lower
part of the cabinet cover.
Disassemble the clamp assembly.
When reassembling the gasket, put the drain
hole of the gasket downward.
GASKET ASSEMBLY
29
Clean the drain pump filter
2
3
2
3
100
1. Open the lower cover
cap
( ) with a tool
such as coin.
Turn the drain plug
( ) to pull out the
hose.
Turn the drain plug
( ) to pull out the
hose.
2. Unplug the drain plug
( ), allowing the water
to flow out. At this time use a vessel to prevent
water from flowing
onto the floor. When water does not flow any
more, turn the pump filter
water from flowing
onto the floor. When water does not flow any
more, turn the pump filter
( ) open to the left.
3. Remove any foreign objects from the
pump filter
( ). After cleaning, turn the
pump filter
( ) clockwise and insert the
drain plug
( ) to the original place.
Close the lower cover cap
( ).
• Allow the water to cool down before cleaning the drain pump filter.
Disassemble the back cover.
Remove the bolt.
Pull out the Rotor.
Unscrew the 2 screws from the tub bracket.
Remove the 6 bolts on the stator.
Unplug the 2 connectors from the stator.
Disassemble the damper hinges from the tub
and base.
Separate the dampers.
NOTE
• Once removed, replace the damper with
new one.
30
Remove pump outlet hose.
Remove tub pump bellows.
Remove cap (Remaining Hose.)
Disconnect the wiring.
Unscrew 2 screws.
Remove the pump.
Loosen the M6 heater nuts to pull out the
HEATER ASSEMBLY.
HEATER ASSEMBLY.
When mounting the HEATER ASSEMBLY be
sure to insert the HEATER ASSEMBLY into the
heater clip on the bottom of the tub.
sure to insert the HEATER ASSEMBLY into the
heater clip on the bottom of the tub.
Pull it out by holding the THERMISTOR
bracket.
If it is pulled by the wire, it may be broken.
When mounting the THERMISTOR again,
make sure
that it is got back tight to the bushing.
bracket.
If it is pulled by the wire, it may be broken.
When mounting the THERMISTOR again,
make sure
that it is got back tight to the bushing.
CAUTION
① Open the door and disassemble the Clamp
assembly.
② Unscrew the 2 screws.
③ Disconnect the connector from the Door
switch assembly.
① Disassemble the back cover.
② Separate the heater from the tub.
③ Remove any foreign objects (wire, coin, etc.)
by inserting a long bar in the opening.
WHEN A FOREIGN OBJECT IS STUCK BETWEEN DRUM AND TUB
31
NOTE
Reconnect the connector after replacing the
DOOR SWITCH ASSEMBLY.
DOOR SWITCH ASSEMBLY.
SWITCH ASSEMBLY, DOOR LOCK
Click on the first or last page to see other 40002 service manuals if exist.