JBL SDP-40 HD (serv.man2) EMC - CB Certificate ▷ View online
Test Number - 251-05
Harman Specialty Group
Lexicon Digital Controller - MC-12 with HDMI interfaces
Harman Specialty Group
Lexicon Digital Controller - MC-12 with HDMI interfaces
1.2 Product Identification, continued
Cable No.
Connection Type
Cable Type Length Terminator
92
Zone 2 Audio Var R
Audio RCA 1 meter 2 kΩ
93
Record Audio Fix L
Audio RCA 1 meter 2 kΩ
94
Record Audio Fix R
Audio RCA 1 meter 2 kΩ
95
Record Audio Var L
Audio RCA 1 meter 2 kΩ
96
Record Audio Var R
Audio RCA 1 meter 2 kΩ
97
Record S/PDIF RCA
RCA
1 meter 75 Ω
98
Record S/PDIF EIAJ
optical
1 meter
99
Balanced Audio Out
Front L
Front L
3 pin XLR 1 meter 2 kΩ
100
Balanced Audio Out
Front R
Front R
3 pin XLR 1 meter 2 kΩ
101
Balanced Audio Out
Center
Center
3 pin XLR 1 meter 2 kΩ
102
Balanced Audio Out LFE 3 pin XLR 1 meter 2 kΩ
103
Balanced Audio Out Sub
L
L
3 pin XLR 1 meter 2 kΩ
104
Balanced Audio Out Sub
R
R
3 pin XLR 1 meter 2 kΩ
105
Balanced Audio Out Side
L
L
3 pin XLR 1 meter 2 kΩ
106
Balanced Audio Out Side
R
R
3 pin XLR 1 meter 2 kΩ
107
Balanced Audio Out
Rear L
Rear L
3 pin XLR 1 meter 2 kΩ
108
Balanced Audio Out
Rear R
Rear R
3 pin XLR 1 meter 2 kΩ
109
Balanced Audio Out Aux
L
L
3 pin XLR 1 meter 2 kΩ
110
Balanced Audio Out Aux
R
R
3 pin XLR 1 meter 2 kΩ
111
Balanced Audio Out
Zone 2 L
Zone 2 L
3 pin XLR 1 meter 2 kΩ
112
Balanced Audio Out
Zone 2 R
Zone 2 R
3 pin XLR 1 meter 2 kΩ
113
3c16 Power cordset
3
meters
meters
Compliance Worldwide, Inc. - 357 Main Street - Sandown, NH 03873
(603) 887 3903 Fax (603) 887 6445
www.complianceworldwide.com
Page 9 of 29
Test Number - 251-05
Harman Specialty Group
Lexicon Digital Controller - MC-12 with HDMI interfaces
1.3 BLOCK DIAGRAM
IN
OUT
All
additional
cables
HDMI
TV
DVD
EUT
HDMI
Compliance Worldwide, Inc. - 357 Main Street - Sandown, NH 03873
(603) 887 3903 Fax (603) 887 6445
www.complianceworldwide.com
Page 10 of 29
Test Number - 251-05
Harman Specialty Group
Lexicon Digital Controller - MC-12 with HDMI interfaces
2.0
EN 61000-4-2 ELECTROSTATIC DISCHARGE TEST DESCRIPTION
2.1 TEST SETUP
The EUT setup was placed in the ESD test laboratory in accordance with the IEC
standard, with the following climatic conditions:
Temperature: 24.1
degrees
C
Relative Humidity: 31 %
The EUT was connected as diagrammed in Section 1.3 of this report.
A horizontal coupling plane (HCP) was placed on a non-conductive table, 0,8 meters
above the ground plane and connected to the ground plane through two 470-kohm
resistors. The EUT was placed on the table with an insulating support between the EUT
and the HCP. The ESD simulator was charged and allowed to discharge through the
HCP See section 9 for photographs of typical setups.
A vertical coupling plane (VCP) measuring 0,5m by 0,5m was fixed 0,1m from the
vertical surfaces of the equipment, parallel to them and connected to the ground plane
through two series 470 kohm resistors. The ESD simulator was charged and allowed to
discharge to the VCP. This test was repeated until all vertical surface areas of the EUT
were exposed to the VCP.
The ESD events were applied to such points and surfaces of the EUT that are normally
accessible to the operator for normal operation or maintenance. Contact discharge is
the preferred test method. Air discharges are used where contact discharge cannot be
applied.
NOTES:
1.
See Section 2.5, for ESD test locations.
Compliance Worldwide, Inc. - 357 Main Street - Sandown, NH 03873
(603) 887 3903 Fax (603) 887 6445
www.complianceworldwide.com
Page 11 of 29
Test Number - 251-05
Harman Specialty Group
Lexicon Digital Controller - MC-12 with HDMI interfaces
2.2 TEST
RESULTS
The Lexicon Digital Controller MC-12 with HDMI interfaces meets the requirements set
forth in EN 61000-4-2. Detailed test results are found in the following table(s).
2.3 TEST DATA
The test results are based upon 10 discharges at both polarities at each test point
Contact Discharge Data
PERFORMANCE CATEGORY
Level
1
Level 2
Level 3
Level
4
VOLTAGE=>
2K
V
4K V
6K V
8K
V
Position Key
+
-
+
-
+
-
+
-
1
A A A A
2
A A A A
3
A A A A
4
A A A A
5
A A A A
6
A A A A
7
A A A A
8
A A A A
9
A A A A
10
A A A A
11
A A A A
12
A A A A
13
A A A A
14
A A A A
15
A A A A
16
A A A A
17
A A A A
18
A A A A
19
A A A A
Compliance Worldwide, Inc. - 357 Main Street - Sandown, NH 03873
(603) 887 3903 Fax (603) 887 6445
www.complianceworldwide.com
Page 12 of 29
Click on the first or last page to see other SDP-40 HD (serv.man2) service manuals if exist.