DOWNLOAD JBL ENCOUNTER (serv.man5) Service Manual ↓ Size: 2.73 MB | Pages: 79 in PDF or view online for FREE

Nemko USA, Inc. 

Figure 4.   ESD Test Setup Diagram 

 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
1.  Test Laboratory (6 x 7 meters) 
2.  Vertical Conducting Wall (3 x 3 m, grounded) 
3.  Ground Plane (14 square meters) 
4.  Ground Rod extending 3 m under ground plane 
5.  Non-Conducting table for ESD Simulator Control Box 
6.  ESD Simulator Control Box on cart 
7.  Electro-Static Discharge (ESD) Gun (hand held, grounded to grounding rod) 
8.  DC power for devices 
9.  Ground strap with two 470kOhm resistors 
10. Grounding Strap 
11.  Horizontal Coupling Plane, grounded to Grounding Rod 
12. Insulating Mat 
13.  Vertical Coupling Plane 
14.  EUT and Associated System 
 
 

1 

2 

3 

4 

6 

7

5 

8 

9 

11

12 

10 

13 

14 

Nemko USA, Inc. 

 
This test bombards the EUT with electric fields that may couple into the system via chassis slots and interface 
cables and evaluates the product’s immunity.  Testing was performed in accordance with IEC 61000-4-3.  The 
RF immunity test entails subjecting the equipment under test to a uniform field of radiated electromagnetic 
energy of a specified field strength and frequency, and monitoring the functionality of the device as the 
frequency is swept over a specified frequency range.   
 
The EUT is set up inside a shielded, semi-anechoic chamber with a radiating antenna at a distance of 3 meters 
from the EUT.  For further information, please refer to the technical sections in the IEC 61000-4-3 publication 
in addition to the test results section and photographs of the test set-up provided in this report. 

Nemko USA, Inc. 

 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 
 

 

 
1. Test 

laboratory 

2.  Shielded anechoic chamber (Anechoic absorber material on walls and ceiling; ferrite tiles on ceiling and floor) 
3.  Power Line filters and power distribution breaker box 
4.  Power strip for EUT and peripherals 
5. Transmit 

antennas 

6. E-Field 

sensor 

7.  Monitoring camera for EUT 
8.  Broadband power amplifiers 
9.  E-Field probe monitoring system 
10. Signal Generators 
11. Non-Conducting table 
12.  EUT and Associated System 
 

1 

3 

3 m 

2 

4 

5 

7 

8 

9 

10 

11 

12 

6 

Nemko USA, Inc. 

 

 
This test injects a transient/burst interference onto the AC/DC power supply and signal I/O lines.  Testing was 
performed in accordance with IEC 61000-4-4.  The standard configuration for “type tests” outlined in IEC 
61000-4-4 is used.  For further information, please refer to the technical sections in the IEC 61000-4-4 in 
addition to the test results section and photographs of the test set-up provided in this report.