Harman Kardon HS 2X0 (serv.man4) EMC - CB Certificate ▷ View online
Test report no. SH09100839-001
Page 92 of 106
TRF55013a/effective date: September 15
th
, 2009
18.3 Test Setup and Test Procedure
Measurement was performed in shielded room.
Instruments used were following CISPR 16-1 and EN 55020.
Measurement methods and operation conditions of EUT was according to clause 5.1,
Instruments used were following CISPR 16-1 and EN 55020.
Measurement methods and operation conditions of EUT was according to clause 5.1,
5.2 and 5.6 of EN55020.
18.4 Test Protocol
Temperature
:
22
°C
Relative Humidity:
40%
Test No.
#
Level
[kV]
Polarity
+/-
Line for test
Pass/
Fail
1 1 +/-
a.c.
Mains
Pass
2 X +/-
X
NA
Notes: “NA” means not applicable.
“X” is for other availiable lines.
Observation: The apparatus shall continue to operate as intended after the test.
Conclusion: The EUT met the requirements of Performance B
18.5 Measurement Uncertainty
The measurement uncertainty describes the overall uncertainty of the given measured
value during the operation of the EUT.
Measurement uncertainty of EFT test at main terminal is:
value during the operation of the EUT.
Measurement uncertainty of EFT test at main terminal is:
± 18%
Measurement uncertainty of EFT test at signal/telecom terminal is:
± 18%
The measurement uncertainty is given with a confidence of 95%, k=2.
The measurement uncertainty is traceable to internal procedure TI-036.
The measurement uncertainty is traceable to internal procedure TI-036.
18.6 Additions, Deviations and Exclusions from Standards
None
Test report no. SH09100839-001
Page 93 of 106
TRF55013a/effective date: September 15
th
, 2009
Appendix I Photograph of equipment under test
Test report no. SH09100839-001
Page 94 of 106
TRF55013a/effective date: September 15
th
, 2009
Test report no. SH09100839-001
Page 95 of 106
TRF55013a/effective date: September 15
th
, 2009
Click on the first or last page to see other HS 2X0 (serv.man4) service manuals if exist.