Harman Kardon HK 3380 (serv.man11) EMC - CB Certificate ▷ View online
- Page 4 of 32 -
www.nemko.com
Report No. 65742
Summary of testing:
The apparatus under test is A/V Receiver of insulation class II.
The apparatus have Amplifier Circuits, Tuner Circuit, Several Signal In/Out terminals (RCA, Antenna,
Mini jack) and Speaker terminal provided (see also photos).
The equipment applied condition of tropical climates for Singapore.
Instructions : Instructions/users manual is only in English. The information shall be given in a language
acceptable to the country where the apparatus is intended to be sold.
The apparatus have Amplifier Circuits, Tuner Circuit, Several Signal In/Out terminals (RCA, Antenna,
Mini jack) and Speaker terminal provided (see also photos).
The equipment applied condition of tropical climates for Singapore.
Instructions : Instructions/users manual is only in English. The information shall be given in a language
acceptable to the country where the apparatus is intended to be sold.
List of attachments:
ANNEX ZB TO EN 60 065, SPECIAL NATIONAL CONDITIONS
ANNEX ZC TO EN 60 065, A-DEVIATIONS
National Deviations for Singapore
Photos
Attachment, Tables to EN/IEC 60065 7
th
edition
TRF No: IEC/EN 60065F
- Page 5 of 32 -
www.nemko.com
Report No. 65742
IEC/EN 60065
Clause
Requirement – Test
Result - Remark
Verdict
3 GENERAL
REQUIREMENTS
Safety class of the apparatus ................................. :
Class II
P
4
GENERAL CONDITIONS OF TESTS
4.1.4 Ventilation
instructions
require the use of the test
box
No test box required. Tested
according to manufacturers
instructions
according to manufacturers
instructions
N
5 MARKING
Comprehensible and easily discernible
On front and rear side of the
enclosure
enclosure
P
Permanent durability against water and petroleum
spirit
spirit
Tested with water / spirit
P
5.1 Identification,
maker, model ................................... :
Brand: Harman / Kardon
Model: HK3380/230.
See copy of marking plate.
Model: HK3380/230.
See copy of marking plate.
P
Class II symbol if applicable
Class II symbol is applied in
according to IEC 60417-5172.
according to IEC 60417-5172.
P
Rated supply voltage and symbol .......................... :
AC-symbol (
~
) with 230V
marked
P
Frequency if safety dependant
50Hz
P
Rated current or power consumption ..................... :
200W
P
5.2 Earth
terminal
Class II apparatus
N
Hazardous live terminals
No hazardous live terminals
P
Supply output terminals (other than mains)
The power and current marked
closed to the socket-outlets;
”
closed to the socket-outlets;
”
SWITCHED, 50W MAX, 0.25A”
P
5.3
Use of triangle with exclamation mark
Correct symbol applied:
Imprinted on rear side in
connection with CAUTION of
opening. Further; no incorrect
use of this symbol is found.
Imprinted on rear side in
connection with CAUTION of
opening. Further; no incorrect
use of this symbol is found.
P
5.4
Instructions for use
User information in the
following language: English.
See comments in Summary of
Testing.
following language: English.
See comments in Summary of
Testing.
P
TRF No: IEC/EN 60065F
- Page 6 of 32 -
www.nemko.com
Report No. 65742
IEC/EN 60065
Clause
Requirement – Test
Result - Remark
Verdict
5.4.1
Mains powered equipment not exposed to dripping
or splashing. Warning concerning objects filled
with liquid, etc.
or splashing. Warning concerning objects filled
with liquid, etc.
The user manual includes
information about danger
concerning dripping or
splashing and objects filled
with liquids.
information about danger
concerning dripping or
splashing and objects filled
with liquids.
P
Hazardous live terminals, instructions for wiring
No hazardous live terminals
N
Instructions for replacing lithium battery
No lithium battery in the
equipment
equipment
N
Instructions for modem if fitted
None
N
Class I earth connection warning
Class II apparatus
N
Instructions for multimedia system connection
Not applicable
N
Special stability warning for fixed installation
Not for fixed installation
N
5.4.2
Disconnect device: plug/coupler or all-pole mains
switch location, accessibility and markings
switch location, accessibility and markings
Plug is regarded as disconnect
device and is readily operable.
device and is readily operable.
P
Instructions for permanently connected equipment
Not permanently connected
equipment
equipment
N
6 HAZARDOUS
RADIATION
6.1
Ionizing radiation < 36 pA/kg (0,5 mR/h)
No CRT
N
6.1
EN 60065
European Council Directive 96/29/Euratom of 13
May 1996 10cm from outer surface of apparatus
<1µSv/h (0,1mR/h)
May 1996 10cm from outer surface of apparatus
<1µSv/h (0,1mR/h)
N
6.2
Laser radiation, emission limits to IEC 60825-1 .... :
No laser
N
Emission limits under fault conditions .................... :
N
7
HEATING UNDER NORMAL OPERATING CONDITIONS
7.1
Temperature rises not exceeding specified values,
no operation of fuse links
no operation of fuse links
No fuse links operate during
normal operating conditions.
See also appended table.
normal operating conditions.
See also appended table.
P
7.1.1
Temperature rise of accessible parts
(see appended table)
P
7.1.2
Temperature rise of parts providing electrical
insulation
insulation
(see appended table)
P
7.1.3
Temperature rise of parts acting as a support or as
a mechanical barrier
a mechanical barrier
(see appended table)
P
7.1.4
Temperature rise of windings
(see appended table)
P
TRF No: IEC/EN 60065F
- Page 7 of 32 -
www.nemko.com
Report No. 65742
IEC/EN 60065
Clause
Requirement – Test
Result - Remark
Verdict
7.1.5
Parts not subject to a limit under 7.1.1 to 7.1.4
(see appended table)
P
7.2
Softening temperature of insulating material
supporting parts conductively connected to the
mains carrying a current > 0,2 A at least 150
supporting parts conductively connected to the
mains carrying a current > 0,2 A at least 150
o
C
No temperatures measured
during heating test and fault
condition tests require this test
(7.2) to be performed.
during heating test and fault
condition tests require this test
(7.2) to be performed.
N
8
CONSTRUCTIONAL REQUIREMENTS WITH REGARD TO THE PROTECTION
AGAINST ELECTRIC SHOCK
AGAINST ELECTRIC SHOCK
8.1
Conductive parts covered by lacquer, paper,
untreated textile oxide films and beads etc.
considered to be bare
untreated textile oxide films and beads etc.
considered to be bare
Considered
P
8.2
No shock hazard when changing voltage setting
device, fuse-links or handling drawers etc.
device, fuse-links or handling drawers etc.
Operation “By hand”
not possible
not possible
N
8.3
Insulation of hazardous live parts not provided by
hygroscopic material
hygroscopic material
No hygroscopic materials
N
8.4
No risk of electric shock following the removal of a
cover which can be removed by hand
cover which can be removed by hand
No cover removable by hand
N
8.5
Class I equipment
Class II equipment
N
Basic insulation between hazardous live parts and
earthed accessible parts
earthed accessible parts
N
Resistors bridging basic insulation complying with
14.2.1 a)
14.2.1 a)
N
8.6
Class II equipment and Class II constructions
within Class I equipment
within Class I equipment
Class II apparatus.
P
Reinforced or double insulation between
hazardous live parts and accessible parts
hazardous live parts and accessible parts
Double/Reinforced insulation
complies with requirements
specified in clause 10 and 13.
complies with requirements
specified in clause 10 and 13.
P
Components bridging reinforced or double
insulation complying with 14.1 a) or 14.3
insulation complying with 14.1 a) or 14.3
The apparatus have isolating
transformers.
transformers.
P
Basic and supplementary insulation each being
bridged by a capacitor complying with 14.2.1 a)
bridged by a capacitor complying with 14.2.1 a)
No such capacitors.
N
TRF No: IEC/EN 60065F
Click on the first or last page to see other HK 3380 (serv.man11) service manuals if exist.