Harman Kardon GO AND PLAY (serv.man2) EMC - CB Certificate ▷ View online
<12007721 001>
Page 19 of 102
TRF No.: IECEN60950A
TRF originator: SGS FIMKO
Output ratings (DC)
Model Designation
V
mA
W
Transformer
Model No.
Fuse (F2)
Current Rating
S60-290160-WZL
29
1600
46.4
T51969E
3.15 A
S60-290170-WZL
29
1700
49.3
T51969E
3.15 A
S60-290180-WZL
29
1800
52.2
T51969E
3.15 A
S60-290190-WZL
29
1900
55.1
T51969E
3.15 A
S60-290200-WZL
29
2000
58
T51969E
3.15 A
S60-290207-WZL
29
2070
60
T51969E
3.15 A
S60-300133-WZL
30
1330
40
T51969E
3.15 A
S60-300140-WZL
30
1400
42
T51969E
3.15 A
S60-300150-WZL
30
1500
45
T51969E
3.15 A
S60-300160-WZL
30
1600
48
T51969E
3.15 A
S60-300170-WZL
30
1700
51
T51969E
3.15 A
S60-300180-WZL
30
1800
54
T51969E
3.15 A
S60-300190-WZL
30
1900
57
T51969E
3.15 A
S60-300200-WZL
30
2000
60
T51969E
3.15 A
S60-310129-WZL
31
1290
40
T51969E
3.15 A
S60-310130-WZL
31
1300
40.3
T51969E
3.15 A
S60-310140-WZL
31
1400
43.4
T51969E
3.15 A
S60-310150-WZL
31
1500
46.5
T51969E
3.15 A
S60-310160-WZL
31
1600
49.6
T51969E
3.15 A
S60-310170-WZL
31
1700
52.7
T51969E
3.15 A
S60-310180-WZL
31
1800
55.8
T51969E
3.15 A
S60-310190-WZL
31
1900
58.9
T51969E
3.15 A
S60-310193-WZL
31
1930
60
T51969E
3.15 A
S60-320125-WZL
32
1250
40
T51969E
3 A
S60-320130-WZL
32
1300
41.6
T51969E
3 A
S60-320140-WZL
32
1400
44.8
T51969E
3 A
S60-320150-WZL
32
1500
48
T51969E
3 A
S60-320160-WZL
32
1600
51.2
T51969E
3 A
S60-320170-WZL
32
1700
54.4
T51969E
3 A
S60-320180-WZL
32
1800
57.6
T51969E
3 A
S60-320187-WZL
32
1870
60
T51969E
3 A
<12007721 001>
Page 20 of 102
TRF No.: IECEN60950A
TRF originator: SGS FIMKO
Copy of marking plate(s):
<12007721 001>
Page 21 of 102
IEC 60950 / EN 60950
Clause
Requirement
−
Test
Result – Remark
Verdict
TRF No.: IECEN60950A
TRF originator: SGS FIMKO
1
GENERAL
P
1.5
Components
P
1.5.1
Comply with IEC 60950 or relevant component
standard
Components which were
found to affect safety aspects
comply with the requirements
of this standard or within the
safety aspects of the relevant
IEC component standards.
(see appended table 1.5.1)
P
1.5.2
Evaluation and testing of components
Components which are
certified to IEC and /or
national standards are used
correctly within their ratings.
Components not covered by
IEC standards are tested
under the conditions present
in the equipment.
P
Dimensions (mm) of mains plug for direct plug-in : Not direct plug in type.
N
Torque and pull test of mains plug for direct
plug-in; torque (Nm); pull (N) ................................:
N
1.5.3
Thermal controls
N
1.5.4
Transformers
Transformer used is suitable
for its intended application and
comply with the relevant
requirements of the standard
and particularly Annex C.
P
1.5.5
Interconnecting cables
Interconnection o/p cable to
other device is carrying only
SELV on an energy level
below 240VA.
→
Except the insulation
material, there are no further
requirements to the o/p
interconnection cable.
P
1.5.6
Capacitors in primary circuits ............................... : Between lines: X2 capacitor
according to IEC 60384-
14:1993 with 21 days damp
heat test.
P
1.5.7
Double or reinforced insulation bridged by
components
See below.
P
1.5.7.1
Bridging capacitors
Primary and secondary
bridged by one capacitor
(CY2), which used was
certified as Y1 capacitor
according to IEC 60384-
14/1993.
P
<12007721 001>
Page 22 of 102
IEC 60950 / EN 60950
Clause
Requirement
−
Test
Result – Remark
Verdict
TRF No.: IECEN60950A
TRF originator: SGS FIMKO
1.5.7.2
Bridging resistors
No bridging resistors.
N
1.5.7.3
Accessible parts
See 2.4.
P
1.5.8
Components in equipment for IT power systems
Class II equipment.
N
1.6
Power interface
P
1.6.1
AC power distribution systems
TN power system. IT power
system for Norway.
P
1.6.2
Input current
Highest load according to
1.2.2.1 for this equipment is
the operation with the max.
specified DC-load.
Results see appended table
Results see appended table
P
1.6.3
Voltage limit of hand-held equipment
This appliance is not a hand-
held equipment.
N
1.6.4
Neutral conductor
Class II equipment. Phase
conductors separated to body
by reinforced insulation.
N
1.7
Marking and instructions
P
1.7.1
Power rating
See below.
P
Rated voltage(s) or voltage range(s) (V) .............: AC 100-240V~
P
Symbol for nature of supply for d.c. .....................: Mains from AC source
N
Rated frequency or frequency range (Hz) ............: 47-63Hz
P
Rated current (A) .................................................: 2A MAX.
P
Manufacturer’s name/Trademark ........................: SPEC LIN
P
Type/model ..........................................................: S60-XXXYYY-WZ, S60-
XXXYYY-WZL
(XXX= 090-320, YYY=125-
(XXX= 090-320, YYY=125-
500, Z = H01-H99)
P
Symbol of Class II ................................................: Double square symbol
provided.
P
Other symbols ......................................................: Additional symbols or marking
does not give rise to
misunderstanding.
P
Certification marks ...............................................: See the copy of marking
plate.
N
1.7.2
Safety instructions
User’s manual provided.
P
1.7.3
Short duty cycles
Equipment is designed for
continuous operation.
N
Click on the first or last page to see other GO AND PLAY (serv.man2) service manuals if exist.