DOWNLOAD Harman Kardon BDS 275 (serv.man2) Service Manual ↓ Size: 13.97 MB | Pages: 127 in PDF or view online for FREE

 

5.2. Block Diagram of Test Setup 

5.2.1.In Anechoic Chamber Test Setup Diagram for 30-1000MHz (at 10m Chamber) 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

5.2.2.in Anechoic Chamber Test Setup Diagram for 30-1000MHz (at 3m Chamber) 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

ANTENNA ELEVATION VARIES FROM 1 OR TO 4 METERS 

10m 

TURN TABLE 

(FIBRE GLASS) 

1.5m(L)*1.0m(W)*0.8m(H)

Receiver 

Combining Network 

AMP 

Spectrum Analyzer

PC System 

0.8m

Antenna Elevation Varies From 1 to 4 m(for Horizontal) 

                                                2 to 4 m (for Vertical) 

3.0m 

Turn Table 

(Wood) 

1.5m(L)*1.0m(W)*0.8m(H)

Receiver 

Combining Network 

AMP 

Spectrum Analyzer

PC System

(

Reference Point

) 

5.2.3. In Anechoic (3m) Chamber Test Setup Diagram for 1-6GHz 

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

 

5.3. Test Standard 

EN55022: 2010 (Class B) and EN 55013: 2001+A1: 2003+A2:2006 

5.4. Radiated Emission Limit 

All emanations from a devices or system, including any network of conductors and 

apparatus connected thereto, shall not exceed the level of field strengths specified below: 
Test Standard: EN55013: 2001+A1: 2003+A2:2006 

DISTANCE 

Source 

(Meters) 

FREQUENCY 

(MHz) 

Limits(dB

μV/m)  

Quasi-Peak 

3 

≦

1000 

Fundamental 60 

3 

30~300 

  Harmonics 52 

Local Oscillator 

3 

300~1000 

  Harmonics 56 

3 30~230 

40 

Other 

3 230~1000 

47 

Note: 

(1) Emission level = Antenna Factor + Cable Loss + Reading 

              (2) The lower limit shall apply at the transition frequencies. 

(3) Distance refers to the distance in meters between the test instrument 

antenna and the closed point of any part of the E.U.T. 

 
 

0.8m

Antenna Elevation Varies From 1 to 4 m 

                                     

3.0m

Turn Table 

(Wood) 

1.5m(L)*1.0m(W)*0.8m(H)

Receiver 

Combining Network 

AMP

Spectrum Analyzer

PC System 

(

Reference Point

)

ABSORBER

 

 

Test Standard: EN55022: 2010 

FREQUENCY 

(MHz) 

DISTANCE 

(Meters) 

FIELD STRENGTHS LIMITS 

(dB

μV/m) 

30 ~ 230 

10 

30 

230 ~ 1000 

10 

37 

1000~3000 3  70(Peak) 

50(Average) 

3000~6000 3  74(Peak) 

54(Average) 

Note: 

(1) Emission level = Antenna Factor + Cable Loss + Reading 

          Emission level = Antenna Factor -Amp Factor +Cable Loss + Reading 

(above 1000MHz) 

(2) The lower limit shall apply at the transition frequencies. 

 

(3) Distance refers to the distance in meters between the test instrument 

antenna and the closed point of any part of the E.U.T. 

5.5. EUT Configuration on Test 

The configurations of EUT are listed in Section 3.5. 

5.6. Operating Condition of EUT 

Same as Conducted Emission test that is listed in Section 3.6. except the test set up replaced 

by Section 5.2. 

5.7. Test Procedure 

The EUT was placed on a non-metallic table, 80 cm above the ground plane inside a

 

semi-anechoic chamber. An antenna was located 3 & 10 meters from the EUT on an 
adjustable mast. A pre-scan was first performed in order to find prominent radiated 
emissions. For final emissions measurements at each frequency of interest, the EUT were 
rotated and the antenna height was varied between 1m and 4m in order to maximize the 
emission for EN55022. 2m and 4m on vertical for EN55013. Measurements in both 
horizontal and vertical polarities were made and the data was recorded. In order to find the 
maximum emission, the relative positions of equipments and all of the interface cables 
were changed according to EN55013 and EN 55022 Class B on Radiated Disturbance test. 

 

The bandwidth setting on the test receiver (R&S TEST RECEIVER ESVS10&ESCI) is 
120 kHz. 
The resolution bandwidth of the Agilent Spectrum Analyzer E7405A was set at 1MHz.   
The frequency range from 30MHz to 1000MHz was pre-scanned with a peak detector and 
all final readings of measurement from Test Receiver are Quasi-Peak values. 
 
The frequency range from 1GHz to 6GHz was checked and all final readings of 
measurement were with Peak and Average detector, measurement distance was 3m at 
semi-anechoic chamber. The portion of the test volume that was obstructed by absorber 
placed on the floor (30cm maximum). 
 
Finally, selected operating situations at Anechoic Chamber measurement, all the test 
results are listed in section 5.8. 

 

5.8. Radiated Emission Test Results 

PASS. (All emissions not reported below are too low against the prescribed limits.) 
 

For frequency range 30MHz~1000MHz 
The EUT with the following test modes were tested and selected (mode 1~4) to read Q.P 
values, all the test results are listed in next pages. 

 

EUT: BLU-RAY DISC SYSTEM        Model No. : BDS575 

 

Test Date: Jun.30, 2012    Temperature: 24℃    Humidity: 56% 

 

The details of test modes are as follows： 

Reference Test Data No. 

No. Test 

Mode 

Horizontal 

Vertical 

1. ※ 

2.  

FM 88MHz 

#41 

#42 

3. FM 

98MHz 

#44 

#43 

4. FM 

108MHz 

#45 

#46 

  (  Worst test mode)

※

 

 

For above 1GHz frequency 
The EUT with below test mode 1 was measured within 3m Anechoic Chamber and the test 
results listed in next pages. 
 
All the emissions form 1GHz to 6GHz were PK measured and comply with Average limit, 
so the average levels were deemed to comply with average limit.   
 
Test Date: Jun.30, 2012      Temperature: 24℃          Humidity: 56% 

 

Reference Test Data No. 

No. Test 

Mode 

 Horizontal 

Vertical 

1.  

BD Play  

#40 

#39