Sony XBR-46HX929 / XBR-55HX920 / XBR-55HX929 Service Manual ▷ View online
XBR-46HX929/55HX920/55HX929
75
Sony Corporation
Sony Technology Center
Technical Services
Service Publication Department
9-888-417-03
English
2011CJ74WEB-1
Printed in USA
© 2011.3
is a trademark of Sony Electronics
Reproduction in whole or part without written permission is prohibited. All rights reserved
XBR-46HX929/55HX920/55HX929 A-1
APPENDIX A - REMOVING THE REAR COVER
REAR COVER CAUTION
The Rear Cover for these model have some sharp edges.
XBR-46HX929 ONLY
Refer to the following illustration when handling the Rear Cover.
Handle the
Rear Cover
using these
areas.
Areas with
yellow have
sharp edges.
Use caution
with these areas.
Areas with red
have sharp
edges and are
Not reinforced .
Use caution with
these areas to
avoid damaging
the Rear Cover.
XBR-46HX929 REAR COVER CAUTION POINTS
XBR-46HX929/55HX920/55HX929 A-2
APPENDIX A - REMOVING THE REAR COVER
XBR-55HX920/55HX929 ONLY
Refer to the following illustration when handling the Rear Cover.
Handle the
Rear Cover
using these
areas.
Areas with
yellow have
sharp edges.
Use caution
with these areas.
Areas with red
have sharp
edges and are
Not reinforced .
Use caution with
these areas to
avoid damaging
the Rear Cover.
XBR-55HX920/55HX929 REAR COVER CAUTION POINTS
XBR-46HX929/55HX920/55HX929 A-3
APPENDIX A - REMOVING THE REAR COVER
REMOVING THE POWER CORD AND THE
RU CONNECTOR
The AC Power Cord is connected to the Power Supply Board and
then routed out through the Rear Cover. When removing the Rear
Cover use caution to avoid pulling the AC Power Cord which may
damage the cord.
The RU Connector is connected to the Main Board. When removing
The RU Connector is connected to the Main Board. When removing
the Rear Cover use catuion to avoid pulling the RU Connector which
may damage the Main Board.
Caution: These instructions should be followed whenever
removing the Rear Cover.
1. Remove all screws, include the screw in the AC cover,
from the Rear Cover.
(For detailed information, refer to
“Rear Cover, RU
Board and Switch Unit Removal” on page 49
.)
2. Using a small flat-head screwdriver, push the tab to the
right to lift out the Wireless Antenna Cover located on
the bottom right side of the Rear Cover.
3. Using gloves or a cloth for protection against the sharp
edges, grasp the corner of the Rear Cover from inside
the Wireless Antenna Cover and lift up.
Click on the first or last page to see other XBR-46HX929 / XBR-55HX920 / XBR-55HX929 service manuals if exist.