Sony KV-29FA210 (serv.man2) Service Manual ▷ View online
10
KV-29FA210
KV-29FA210
1-1. REAR COVER REMOVAL
1-2. CHASSIS ASSEMBLY REMOVAL
1-3. SERVICE POSITION
SECTION 1: DISASSEMBLY
TW Board
GW Board
C Board
Chassis Assembly
9
Screws +BVTP 4X16 TYPE2 TT(B)
Rear Cover
7
Screws +BVTP 3X12 TAPPING
A Board
Claw
11
KV-29FA210
KV-29FA210
Make a loop on HV (60mm minimum Diameter)
and dress it together with focus lead using two
9mm purse locks (4-041-996-02), add an HV
holder (4-041-203-01) on the loop.
and dress it together with focus lead using two
9mm purse locks (4-041-996-02), add an HV
holder (4-041-203-01) on the loop.
1
1-4. TW CABLE WIRE DRESSING
Dress HV cable through the DGC purse lock
(4-081-411-02) Install purse lock where the
CRT carbon paint ends.
(4-081-411-02) Install purse lock where the
CRT carbon paint ends.
NOTE: Center of loop must be at same height
as V board’s top edge.
as V board’s top edge.
2
12
KV-29FA210
KV-29FA210
Dress RGB(A/CN303~C/CN705) and heaters
harness (A/CN503~C/CN706) through rear
bracket purse lock (4-072-499-11)
harness (A/CN503~C/CN706) through rear
bracket purse lock (4-072-499-11)
3
Dress CRT ground wires into C-board hook.
NOTE : Keep as far as possible from HV wires.
NOTE : Keep as far as possible from HV wires.
Bend H-stat wire towards C-board.
4
Make a loop with DY lead wire and VM harness
(A/CN502~V/CN901) using 9mm purse locks.
(4-041-996-02)
(A/CN502~V/CN901) using 9mm purse locks.
(4-041-996-02)
5
13
KV-29FA210
KV-29FA210
Dress Right Speaker wire and connector
A/CN505~GW/CN602 into Beznet Purse Lock
(4-072-499-11).
A/CN505~GW/CN602 into Beznet Purse Lock
(4-072-499-11).
6
Dress DGC lead wire through DGC tie wrap.
Dress Rotation coil lead wire into DY frame.
Dress Rotation coil lead wire into DY frame.
7
Dress Left Speaker wire through DGC tie wrap.
8
Click on the first or last page to see other KV-29FA210 (serv.man2) service manuals if exist.