Sony KV-25C2A Service Manual ▷ View online
KV-25C2
— 19 —
DISASSEMBLY
SECTION 2
2-1. REAR COVER REMOVAL
3
Rear Cover
2-2. CHASSIS ASSY REMOVAL
2-3. SERVICE POSITION
1
One screw
(BVTP 4x16)
(BVTP 4x16)
Four screws
(BVTP 4x16)
(BVTP 4x16)
2
2-4. WIRE DRESSING
KV-25C2
— 20 —
2-5. A BOARD REMOVAL
A board
•
HOW TO HANDLE AN ANODE-CAP
Don't damage the surface of anode-cap with sharp shaped material !
Don't press the rubber hardly not to hurt inside of anode-caps !
A metal fitting called as shatter-hook terminal is built into the rubber.
Don’t turn the foot of rubber over hardly !
The shatter-hook terminal will stick out or damage the rubber
Don't press the rubber hardly not to hurt inside of anode-caps !
A metal fitting called as shatter-hook terminal is built into the rubber.
Don’t turn the foot of rubber over hardly !
The shatter-hook terminal will stick out or damage the rubber
.
1
2
3
b
b
Anode button
a
* REMOVING PROCEDURES.
c
Turn up one side of the rubber cap in
the direction indicated by the arrow a
the direction indicated by the arrow a
1
2 Using a thumb pull up the rubber cap
firmly in the direction indicated by the
arrow b
arrow b
3
When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling it up in
the direction of the arrow c
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling it up in
the direction of the arrow c
•
REMOVAL OF ANODE-CAP
Note:
Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or
carbon paint on the CRT, after removing the anode.
2-6. PICTURE TUBE REMOVAL
Anode cap
1
4
Deflection yoke
2
Chassis assy
3
C board
Two DGC holers
5
7
Spring extension
6
Degaussing coil
8
Four PT screws
Picture tube
9
Box assy
9
Box assy
Cushion
10
Click on the first or last page to see other KV-25C2A service manuals if exist.