Sony KV-16WS1A Service Manual ▷ View online
KV-16WS1
— 16 —
SECTION 3
SET-UP ADJUSTMENTS
Puri
Preparation:
•
In order to reduce the influence of external magnetic
forces on the picture tube, face the TV set in an easterly
or westerly direction.
forces on the picture tube, face the TV set in an easterly
or westerly direction.
•
Turn the power switch for the unit ON and erase the
magnetic force using a degausser.
magnetic force using a degausser.
3-1. BEAM LANDING
Demagnetize with a degausser.
1.
1.
Input an all white raster signal from the pattern generator.
CONTRAST
BRIGHTNESS
BRIGHTNESS
2.
Switch the raster signal of the pattern generator to Red.
3.
Move the deflection yoke backward, and adjust with the
purity control so that Red is at the centre and the Blue and
Green are evenly spaced at the sides. see (Fig. 3-1 - 3-3)
purity control so that Red is at the centre and the Blue and
Green are evenly spaced at the sides. see (Fig. 3-1 - 3-3)
4.
Move the deflection yoke forward, and adjust so that the
entire screen becomes Red. (Fig. 3-1)
entire screen becomes Red. (Fig. 3-1)
5.
Switch the raster signal to Blue and then Green to confirm
the condition.
the condition.
6.
When the position of the deflection yoke has been
determined, tighten it with the deflection yoke mounting
screw.
determined, tighten it with the deflection yoke mounting
screw.
7.
When the landing at the corners is not correct, adjust by
using disk magnets. (Fig. 3-4)
using disk magnets. (Fig. 3-4)
Fig. 3-1
normal
Perform the adjustments in the following order:
1.
1.
Beam Landing
2.
Convergence
3.
Screen (G2), Drive, White Balance, Sub Colour and
Sub Brightness.
Sub Brightness.
4.
Focus
Note: Test Equipment Required.
1. Colour bar/Pattern Generator
2. Degausser
3. DC Power Supply
4. Digital multimeter
5. Oscilloscope
2. Degausser
3. DC Power Supply
4. Digital multimeter
5. Oscilloscope
•
The following adjustments should be made when a complete
realignment is required or a new picture tube is installed.
realignment is required or a new picture tube is installed.
•
These adjustments should be performed with the rated
power supply voltage, unless otherwise noted.
power supply voltage, unless otherwise noted.
The Contrast and Brightness controls should be set as follows
unless otherwise noted:
unless otherwise noted:
CONTRAST control ............... 80%
(or Normal by commander)
BRIGHTNESS control ........... 50%
Purity control
Fig. 3-2
Fig. 3-3
Fig. 3-4
GRN
BLU
RED
Green
Blue
Red
Purity control corrects
this area
Disk magnets or
rotatable disk
magnets correct
these areas (a-d).
Deflection yoke pos.
corrects these areas
Click on the first or last page to see other KV-16WS1A service manuals if exist.