Sony KLV-V26A10 / KLV-V32A10 / KLV-V40A10 (serv.man5) Service Manual ▷ View online
KLV-V26/V32/V40A10 (CH) 2-16
KLV-V40A10
2-2-11. H6 BOARD REMOVAL
2-2-11. H6 BOARD REMOVAL
2-2-12. H7 BOARD AND SPEAKER REMOVAL
1
Multi botton bracket
3
Multi botton
2
H6 board
3
One screw
(+PWTP 4x16)
5
Two screws
(+BVTP 3x12)
6
H7 boad
7
Guide light
4
Loudspeaker (R)
1
One screw
(+PWTP 4x16)
2
Loudspeaker (L)
KLV-V26/V32/V40A10 (CH) 2-17E
KLV-V40A10
2-2-13. LCD BOARD REMOVAL
2-2-13. LCD BOARD REMOVAL
1
Twelve screws
(+BVTP2 4x16)
2
Chassis bracket
3
LCD panel
Bezel assy
4
Harness with connector (LVDS)
KLV-V26/V32/V40A10 (CH) 3-1E
3-1. DISPLAYING SERVICE MENU
(1) Turn ON the power of the TV set, and drive it into the standby mode by the remote control.
(2) Press the buttons on the remote control as follows.
(2) Press the buttons on the remote control as follows.
Analog service menu
MIX5
DISPLAY
→ TEN KEY “5” → VOL “+” → TV POWER
3-2. ADJUSTMENT USING THE SERVICE MENU
Set adjustment values using the”
” keys and the “ ” key.
3-3. SELF CHECK MENU
For errors eith symptoms such as “power sometimes shuts off” or “screen sometimes goes out” that cannot be confirmed, it is possible
to bring up past occurances of failure for confirmation on the screen:
to bring up past occurances of failure for confirmation on the screen:
[ To bring up screen test]
In stand by mode, press buttons on the remote commander sequentially in repid succession as shown below:
DISPLAY
In stand by mode, press buttons on the remote commander sequentially in repid succession as shown below:
DISPLAY
→ TEN KEY “5” → VOL“-” →TV power
↑ Note that this differs from entering the service mode(mode volume “+”)
Self-check scrren display
SELF CHECK
2: TEMP_ERROR
0
3: PLUS_B_OVP
0
4: FAN_ERROR
0
6: LOW_B_ERROR 0
7: AUDIO_PROT
7: AUDIO_PROT
0
8: D_OVP
0
9: BL_ERROR
0
TIME:00000H
MODEL:KLV-V-----
SERIAL:00000000
MODEL:KLV-V-----
SERIAL:00000000
SECTION 3
SERVICE MODE
Numeral “0” means that no faults has been detected.
Numeral “0” means a fault has been detected.
KLV-V26/V32/V40A10 (CH) 4-1
SECTION 4
DIAGRAMS
•
Schematic diagrams provided by the design section are included in this manual.
•
Block diagrams, frame diagrams, and board layouts will be included by October 11.
Click on the first or last page to see other KLV-V26A10 / KLV-V32A10 / KLV-V40A10 (serv.man5) service manuals if exist.