Sony KDL-32V5500 / KDL-40V5500 / KDL-40W5500 / KDL-46V5500 / KDL-46W5500 / KDL-46WE5 / KDL-52V5500 / KDL-52W5500 / KLV-32V530A / KLV-40V530A / KLV-46V530A Service Manual ▷ View online
KDL-32/40/46/52V5500, 40/46/52W5500, 46WE5, KLV-32/40/46V530A (CH) 12
Model name
KDL-46WE5
System
Panel System
LCD (Liquid Crystal Display) Panel
TV System
Analogue: D/K, I, B/G, M
Digital: GB20600-2006
Digital: GB20600-2006
Colour System
Analogue: PAL, PAL60, SECAM, NTSC4.43, NTSC3.58
Digital: MPEG-2 MP@ML MP@HL
Digital: MPEG-2 MP@ML MP@HL
Channel Coverage
Analogue: D/K: VHF: C1 to C12, R1 to R12/ UHF: C13 to C57, R21 to R60/
CATV: S01 to S03, S1 to S41, Z1 to Z39
I: UHF: B21 to B69/ CATV: S01 to S03, S1 to S41
B/G: VHF: E2 to E12/ UHF: E21 to E69/ CATV: S01 to S03, S1 to S41
M: VHF: A2 to A13/ UHF: A14 to A79/ CATV: A-8 to A-2, A to W+4,
B/G: VHF: E2 to E12/ UHF: E21 to E69/ CATV: S01 to S03, S1 to S41
M: VHF: A2 to A13/ UHF: A14 to A79/ CATV: A-8 to A-2, A to W+4,
W+6 toW+84
Digital:GB20600-2006
Sound Output
8.5 W + 8.5 W (at 7% distortion)
Input/Output jacks
Aerial/Antenna/Cable
75 ohm external terminal for VHF/UHF
1
S video input (4-pin mini DIN)
1
Video input/Video output
1
Audio input/Audio output
2
Video input
2
Audio input: 500 mVrms, 47 kilohms
Component IN 1/
3
Component IN 1:
Supported formats: 1080p (50/60 Hz), 1080i (50/60 Hz), 720p (50/60 Hz), 576p, 576i,
480p, 480i
Y: 1 Vp-p, 75 ohms, 0.3V negative sync/P
B
/C
B
: 0.7 Vp-p, 75 ohms/
P
R
/C
R
: 0.7 Vp-p, 75 ohms
3:
Video input
Component IN 1/
3
Audio input: 500 mVrms, 47 kilohms
Component IN 2
Supported formats: 1080p (50/60 Hz), 1080i (50/60 Hz), 720p (50/60 Hz), 576p, 576i,
480p, 480i
Y: 1 Vp-p, 75 ohms, 0.3V negative sync/P
B
/C
B
: 0.7 Vp-p, 75 ohms/
P
R
/C
R
: 0.7 Vp-p, 75 ohms
Component IN 2
Audio input: 500 mVrms, 47 kilohms
HDMI INPUT1, 2, 3, 4
Video: 1080/24p, 1080p (50/60 Hz), 1080i (50/60 Hz), 720p (50/60 Hz), 576p, 576i,
480p, 480i
Audio: Two channel linear PCM 32, 44.1 and 48 kHz, 16, 20 and 24 bits
Analogue audio input (minijack): 500 mVrms, 47 kilohms (HDMI IN 1 only)
PC Input
DIGITAL AUDIO OUT (OPTICAL)
Digital optical jack (Two channel linear PCM)
Audio output
PC IN
PC Input (D-sub 15-pin)
G: 0.7 Vp-p, 75 ohms, non Sync on Green/B: 0.7 Vp-p, 75 ohms/
R: 0.7 Vp-p, 75 ohms/HD: 1-5 Vp-p/VD: 1-5 Vp-p
G: 0.7 Vp-p, 75 ohms, non Sync on Green/B: 0.7 Vp-p, 75 ohms/
R: 0.7 Vp-p, 75 ohms/HD: 1-5 Vp-p/VD: 1-5 Vp-p
PC audio input (minijack)
USB
USB port
Headphones
Headphones jack
LAN
10BASE-T/100BASE-TX connector (Depending on the operating environment of the
network, connection speed may differ. 10BASE-T/100BASE-TX communication rate
and communication quality are not guaranteed for this TV.)
network, connection speed may differ. 10BASE-T/100BASE-TX communication rate
and communication quality are not guaranteed for this TV.)
Power and others
Power Requirements
220 V AC, 50 Hz
Viewing Screen Size (diagonal)*
117 cm (46 inches)
Display Resolution
1,920 dots (horizontal)
× 1,080 lines (vertical)
Power Consumption
160 W
Standby Power Consumption**
Less than 0.2 W (16 W when “Quick Start” is set to “On”)
■
KDL-46WE5
KDL-32/40/46/52V5500, 40/46/52W5500, 46WE5, KLV-32/40/46V530A (CH) 13
* Dimensions and mass are approximate values.
** Specified standby power is reached after the TV finishes necessary internal processes.
** Specified standby power is reached after the TV finishes necessary internal processes.
* Refer to SJ/T11348-2006 <Methods of measurement for digital television flat panel displays>.
** These values are required by SJ/T11343-2006 <General specification for digital television LCD displays>
** These values are required by SJ/T11343-2006 <General specification for digital television LCD displays>
in normal temperature.
Design and specifications are subject to change without notice.
Dimensions*
(w
(w
× h × d)
with Table-Top Stand
(mm)
(mm)
1,123
× 772 × 330
without Table-Top Stand
(mm)
(mm)
1,123
× 725 × 107
Mass*
with Table-Top Stand
(kg)
(kg)
26.5
without Table-Top Stand
(kg)
(kg)
23.2
Product usage condition
Environment Temperature
5
°C - 35°C
Humidity
20% - 80%
Air Pressure
86 kPa - 106 kPa
Model name
KDL-46WE5
Display Spec
Luminance*
350 cd/m
2
**
Contrast*
150:1 **
Viewing angle (L
0
/3)*
Horizontal
85
° Vertical 65°
Definition (TV
Line)*
Line)*
analog RF
Horizontal 350, Vertical 400 TVL**
SDTV
Horizontal 450, Vertical
450 TVL**
HDTV
Horizontal 720, Vertical 720 TVL**
Colour gamut*
32% **
Smearing time of motion picture*
20 ms**
Audio characteristic*
Sound pressure THD in rated input 10%**
Model name
KDL-46WE5
KDL-32/40/46/52V5500, 40/46/52W5500, 46WE5, KLV-32/40/46V530A (CH) 14
PC in put signal reference chart for
(RGB) PC and HDMI IN 1, 2, 3, 4
* 1080p timing when applied to the HDMI input will be treated as a video timing and not a PC timing. This
affects the “Video Settings” menu and “Screen” menu settings.
To view PC contents, set “Wide Mode” to “Full” and “Display Area” to “Full Pixel.”
To view PC contents, set “Wide Mode” to “Full” and “Display Area” to “Full Pixel.”
• This TV’s PC input does not support Sync on Green or Composite Sync.
• This TV’s PC input does not support interlaced signals.
• If input signal is not shown in above chart, then this signal may not be displayed properly or cannot be
• This TV’s PC input does not support interlaced signals.
• If input signal is not shown in above chart, then this signal may not be displayed properly or cannot be
displayed according to your setting.
• For the best picture quality, it is recommended to use the signals in the above chart with a 60 Hz vertical
frequency (boldfaced).
Resolution
Horizontal
frequency (kHz)
Vertical
frequency (Hz)
Standard
Signals
Horizontal
(Pixel)
(Pixel)
×
Vertical
(Line)
VGA
640
×
480
31.5
60
VESA
640
×
480
37.5
75
VESA
720
×
400
31.5
70
VESA
SVGA
800
×
600
37.9
60
VESA
800
×
600
46.9
75
VESA
XGA
1024
×
768
48.4
60
VESA
1024
×
768
56.5
70
VESA
1024
×
768
60.0
75
VESA
WXGA
1280
×
720
45.0
60
EI A
1280
×
768
47.4
60
VESA
1280
×
768
47.8
60
VESA
1280
×
960
60.0
60
VESA
1360
×
768
47.7
60
VESA
SXGA
1280
×
1024
64.0
60
VESA
HDTV
1920
×
1080
66.6
60
VESA*
1920
×
1080
67.5
60
EIA*
KDL-32/40/46/52V5500, 40/46/52W5500, 46WE5, KLV-32/40/46V530A (CH) 15
CAUTION
These servicing instructions are for use by qualified service
personnel only.
To reduce the risk of electric shock, do not perform any servicing
other than that contained in the operating instructions unless you
are qualified to do so.
personnel only.
To reduce the risk of electric shock, do not perform any servicing
other than that contained in the operating instructions unless you
are qualified to do so.
WARNING!!
An isolation transformer should be used during any service to
avoid possible shock hazard, because of live chassis.
The chassis of this receiver is directly connected to the ac power
line.
avoid possible shock hazard, because of live chassis.
The chassis of this receiver is directly connected to the ac power
line.
!
SAFETY-RELATED COMPONENT
WARNING!!
Replace all components with Sony parts whose part numbers
appear as shown in this manual or in supplements
published by Sony.
appear as shown in this manual or in supplements
published by Sony.
WARNINGS AND CAUTIONS
SAFETY-RELATED COMPONENT
WARNING
It is essential that all critical parts be replaced only with the part
number specified in the electrical parts list to prevent electric
shock, fire, or other hazard.
number specified in the electrical parts list to prevent electric
shock, fire, or other hazard.
NOTE: Do not modify the original design without obtaining
written permission from the manufacturer or you will
void the original parts and labor guarantee.
void the original parts and labor guarantee.
USE CAUTION WHEN HANDLING THE LCD PANEL
When repairing the LCD panel, be sure you are grounded by
using a wrist band.
using a wrist band.
When repairing the LCD panel on the wall, the LCD panel must
be secured using the 4 mounting holes on the rear cover.
1) Do not press on the panel or frame edge to avoid the risk of
be secured using the 4 mounting holes on the rear cover.
1) Do not press on the panel or frame edge to avoid the risk of
electric shock.
2) Do not scratch or press on the panel with any sharp objects.
3) Do not leave the module in high temperatures or in areas of
3) Do not leave the module in high temperatures or in areas of
high humidity for an extended period of time.
4) Do not expose the LCD panel to direct sunlight.
5) Avoid contact with water. It may cause a short circuit within
5) Avoid contact with water. It may cause a short circuit within
the module.
6) Disconnect the AC power when replacing the backlight (CCFL)
or inverter circuit.
(High voltage occurs at the inverter circuit at 650Vrms.)
(High voltage occurs at the inverter circuit at 650Vrms.)
7) Always clean the LCD panel with a soft cloth material.
8) Use care when handling the wires or connectors of the inverter
8) Use care when handling the wires or connectors of the inverter
circuit. Damaging the wires may cause a short.
9) Protect the panel from ESD to avoid damaging the electronic
circuit (C-MOS).
[Insertion ]
(1) Hold the center of a
connector.
connector.
(2) Press the center of the
connector to insert it.
(3) Slide the slider to lock the
connector.
Lock
[ Detachment ]
(1) Slide the slider to release
the slider lock.
the slider lock.
(2) Press the center lock tab
to release the lock and pull
the connector up.
to release the lock and pull
the connector up.
Unlock
ATTACHMENT & DETACHMENT OF MDF61 CONNECTOR
Click on the first or last page to see other KDL-32V5500 / KDL-40V5500 / KDL-40W5500 / KDL-46V5500 / KDL-46W5500 / KDL-46WE5 / KDL-52V5500 / KDL-52W5500 / KLV-32V530A / KLV-40V530A / KLV-46V530A service manuals if exist.