View Sony DPP-F700 Service Manual online
SERVICE MANUAL 9-852-727-11
with this manual.
Instructions of DPP-F700 (4-155-700-14 (1)).
SD memory card slot/
xD-Picture Card slot/MMC card slot/
CompactFlash card slot
(800 × 3(RGB) × 480) dots
LCD screen area:
Total number of dots:
(768 × 3 (RGB) × 480) dots
(before brightness of the backlight is
pack designed for the printer.
On standby mode: less than 1 W
the internal memory with the default settings
without inserting a memory card.
(10 7/8 × 5 7/8 × 7 3/8 in.)
(With the stand spread out)
(5 7/8 × 10 7/8 × 7 1/4 in.)
(With the stand spread out)
Approx. 276 × 85 × 149 mm (w/h/d)
(10 7/8 × 3 3/8 × 5 7/8 in.)
Depth with paper tray attached:
Approx. 306 mm (12 in.)
115g (4 oz), ink ribbon and AC
size). For the total No. of prints, see [System
Information] in the Settings menu.
or more may not be displayed properly. Even if the
aspect ratio is less than 20:1, display problem may
occur in thumbnails, slideshow or other occasions.
files for management and applications are
included. Approximately 940 MB.
When resizing and importing images, they are
automatically resized to about 2,000,000 pixels.
This varies depending on the subject and shooting
1.5 A to 0.75 A
(2 3/8 × 1 1/4 × 4 7/8 in.)
(excluding the protruding parts and
• Cleaning sheet (1)
• Read This First (1)
• About the Print Packs (1)
• Warranty (In some regions, the warranty is
purchased this unit.
size and format of image data and operating
is set to [ON].
(file size about 4.1 MB) and stored on the internal
memory with this unit set to [Resize] (file size
about 400 KB).
in the slot of this unit.
dered connections. Check the entire board surface for solder
splashes and bridges.
"pinched" or contact high-wattage resistors.
tors, that were installed during a previous repair. Point them
out to the customer and recommend their replacement.
of deterioration. Point them out to the customer and recom-
mend their replacement.
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
• Unleaded solder melts at a temperature about 40
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
heated tip is applied for too long, so be careful!
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
also be added to ordinary solder.
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
from the printer block.