Sony SAL300F28G Service Manual ▷ View online
5-5
SAL300F28G (2.8/300 G) (300mm F2.8 G)
2. Setup of PC Card
1)
Double-click “InstaCal.msi” in “C:\MCC” folder to begin the installation.
Fig.5-1-8
2)
The menu to begin the installation appears. Click
[Next>]
.
Fig.5-1-9
3)
Specify the install destination folder. As the default is used for it, click
[Next>]
.
Fig.5-1-10
5-6
SAL300F28G (2.8/300 G) (300mm F2.8 G)
4)
The menu to tell that the wizard is ready to install appears. Click
[Install]
.
Fig.5-1-11
5)
The installation is completed. Click
[Finish]
.
Note:
To refer to the “readme” file, check the “Show the readme file” and click
[Finish]
.
Fig.5-1-12
6)
To make the configuration installed effective, the window to prompt the restart appears.
Click “Yes” to restart the PC.
Note:
If a device is connected without restarting, the program may not work properly.
Fig.5-1-13
5-7
SAL300F28G (2.8/300 G) (300mm F2.8 G)
7)
After restarting the PC, insert the PC-CARD-DIO48 in the PC card slot.
8)
The software installation window appears.
Click “Install the software automatically. (Recommended)”.
Fig.5-1-14
9)
The software is detected and installed. When the window below appears, click
[Finish]
to terminate the installation.
Fig.5-1-15
5-8
SAL300F28G (2.8/300 G) (300mm F2.8 G)
3. Confirmation of PC card setting
1)
Select “All programs” - “MeasumentComputing” - “InstaCal” from the startup menu, and start up the software.
Note:
Depending on the Windows setting, the window below may differ.
Fig.5-1-16
2)
When “PC-CARD-DIO48” is detected, the window below appears. Confirm that the PC-CARD-DIO48” is checked.
Note:
Depending on the slot inserted, the slot No. differs.
Fig.5-1-17
3)
Confirm that “PC-CARD-DIO48” is recognized as “Board#0”.
Note:
If not recognized as “Board#0”, the program does not work properly.
Fig.5-1-18
4)
Click “File” - “Exit” to terminate “InstaCal”.
Click on the first or last page to see other SAL300F28G service manuals if exist.