DOWNLOAD Sony DSC-V3 (serv.man2) Service Manual ↓ Size: 10.27 MB | Pages: 57 in PDF or view online for FREE

1-1

DSC-V3

The charging capacitor (C205) is charged up to the maximum 300
V potential.
There is a danger of electric shock by this high voltage when the
capacitor is handled by hand.  The electric shock is caused by the
charged voltage which is kept without discharging when the main
power of the unit is simply turned off.  Therefore, the remaining
voltage must be discharged as described below.

To preparing the short jig, a small clip is attached to each end of a
resistor of 1 k

Ω /1 W (1-215-869-11).

Wrap insulating tape fully around the leads of the resistor to prevent
electrical shock.

1 k

Ω

/1 W

Wrap insulating tape.

Short-circuit between the positive and the negative terminals of
charged capacitor with the short jig about 10 seconds.

Make sure that the flat cable and flexible board are not cracked of
bent at the terminal.
Do not insert the cable insufficiently nor crookedly.

Cut and remove the part of gilt 
which comes off at the point.
(Be careful or some 
pieces of gilt may be left inside) 

When remove a connector, don’t pull at wire of connector.
It is possible that a wire is snapped.

When installing a connector, don’t press down at wire of connector.
It is possible that a wire is snapped.

R:1 k

Ω

/1 W

 

(Part code: 
1-215-869-11)

1-2

DSC-V3

When tightening a screw, have both sides of the lens block assembly
so as not for the load to depend.

M1.7

M1.7

ST ground plate

Lens block assembly

Lens flame

The laser diode may suffer electrostatic breakdown because of the
potential difference generated by the charged electrostatic load, etc.
on clothing and the human body.
During repair, pay attention to electrostatic breakdown and also use
the procedure in the printed matter which is included in the repair
parts.
The flexible board is easily damaged and should be handled with
care.

Adjustment is needed when laser unit (D109) on the AF-
008 flexible board is replaced.
Refer to “CAMERA adjustmen 5” and “CAMERA
adjustment 6” of SERVICE MANUAL, ADJ (9-876-762-
51.pdf).

Laser unit
(D109)

1-3E

DSC-V3

• C: ss: ss

You can reverse the camera
malfunction yourself. (However,
contact your Sony dealer or local
authorized Sony service facility
when you cannot recover from the
camera malfunction.)

• E: ss: ss

Contact your Sony dealer or local
authorized Sony service facility.

Display Code

  C:32:ss

  C:13:ss

Countermeasure

Turn the power off and on again.

Format the recording medium.

Insert a new recording medium.

Cause

Trouble with hardware.

Unformatted recording medium is inserted.

Recording medium is broken.

Caution Display During Error

SYSTEM ERROR

FORMAT ERROR

MEMORY STICK ERROR,
CF CARD ERROR

  E:61:ss

  E:91:ss

Checking of lens drive circuit.

When failed in the focus and zoom
initialization.

Checking of flash unit or replacement
of flash unit.

—

Abnormality when flash is being
charged.

DSC-V3