Sony DSC-S3000 (serv.man3) Service Manual ▷ View online
– 9 –
DSC-S3000_L2
To this cam
groove
The phase of drive gear portion
The only thin projection should be located
around this phase.
around this phase.
The inner-block_3
DRIVE CAM BARREL
The inner-block_2
(3)
While aligning the inner-block_3 with the DRIVE CAM BARREL in the phase relation shown below, assemble
these parts as the inner-block_2.
these parts as the inner-block_2.
FPC
To this
groove
The only thin projection
should be located
around this phase.
should be located
around this phase.
The inner-block_2
SHUTTER ASSY
The inner-block_1
(4)
While aligning the SHUTTER ASSY with the inner-block_2 in the phase relation shown below,
assemble these parts as the inner-block_1.
assemble these parts as the inner-block_1.
– 10 –
DSC-S3000_L2
FPC
Hole for FPC
FIXED BARREL
The inner-block_1
Placed
(5)
While aligning the inner-block_1 with the FIXED BARREL in the phase relation shown below,
place the inner-block_1 into the FIXED BARREL.
place the inner-block_1 into the FIXED BARREL.
Half-extend barrel
Tele-end
Passed
Hole for FPC
FPC
(6) Turn the gear part in the arrow direction with a flat-blade screwdriver.
(7) Turn the half-extend barrel in the arrow direction to the Tele-end.
(8) Pass the FPC through the hole.
– 11 –
DSC-S3000_L2
Nut
To this range
FOCUSING
SHAFT ASSY
SHAFT ASSY
REAR LENS
REAR LENS
SPRING
SPRING
Engaged
(9) Turn the nut of FOCUSING SHAFT ASSY in the arrow direction to move it to the position shown below.
(10) Hook the FOCUSING SHAFT ASSY and the REAR LENS SPRING to the REAR LENS as a unit as shown in the figure.
Then engage the unit with the groves of the FIXED BARREL as shown in the figure.
COVER TAPE
The end-loop of REAR LENS SPRING
PI part
Double faced tape
under this part
under this part
Hook
PI part
(11) Hook the end-loop of REAR LENS SPRING, and then attach the COVER TAPE.
(12) Arrange the FPC as shown in the figure.
(13) Turn the Tele-ended barrel in the arrow direction to the retracted position.
– 12 –
DSC-S3000_L2
2ND FOCUS GEAR
ZOOM LONG GEAR
(14) Install the 2ND FOCUS GEAR and the ZOOM LONG GEAR.
(15) Install the REAR RETAINER.
(16) Install the four screws. (4-277-820-01)
REAR RETAINER
To retract, apply a positive supply voltage (+) here.
To Tele, apply a positive supply voltage (+) here.
(17) Solder the connection.
(18) To test the assembly, apply a voltage of 2.5 VDC to the zoom motor.
Click on the first or last page to see other DSC-S3000 (serv.man3) service manuals if exist.