Sony DSC-RX100M4 (serv.man2) Service Manual ▷ View online
4-2-9.
Lens Block Section
• Refer to
“Lens Block Section”
on exploded view for Ref. No.
(Claws)
(Claws)
(Claw)
#176
#302
#258
#258
(Note 1)
(Note 2)
405
407
409
401
406
403
404
402
408
(including IC1003
(CMOS imager) and
CD-1006A flexible board)
(CMOS imager) and
CD-1006A flexible board)
410
411
ns
ns
ns
ns
ns
ns
ns
ns
DSC-RX100M4
4-21
Note 1
Hold the Lens Block at the
center of both sides.
Do not hold the following part.
Hold here.
NOTES ON HOLDING THE LENS BLOCK
Lens barrier
*Very weak
Zoom motor,
Gear B
Gear B
*Very weak
G10 lens
*Very weak
Note 2
Do not reuse these Parts because their adhesive force
decreases when they are removed once.
decreases when they are removed once.
これらの部品は一度剥がすと粘着力が弱くなるため,再利用は
しないでください。
しないでください。
DSC-RX100M4
4-22
4-3.
Lens Block
4-3-1.
Ornamental Ring (A) or Barrier Block Assy Replacing Method
Removal
1.
Turn on the power switch and extend the lens (WIDE end).
2.
Detach the battery.
3.
Apply alcohol to the gap of the Ornamental Plate using tweezers or fine-tipped stick as shown below.
4.
Detach the Ornamental Ring (A).
Boss
Solvent
Tweezers
Ornamental Ring (A)
Do not turn the Ornamental Ring (A) because there is a
Positioning Boss. Detach the Ornamental Ring A in the
arrow direction.
Positioning Boss. Detach the Ornamental Ring A in the
arrow direction.
Note:
Ornamental Ring (A)は,位置決めのボスがあるため,
左右にひねらず矢印方向に取り外してください。
左右にひねらず矢印方向に取り外してください。
Note:
5.
Disengage the four claws and remove the Barrier Block Assy.
Barrier Assy
Claws
Claws
Installation
1.
Fit the four claws while inserting the barrier lever into the hole and attach the Barrier Block Assy.
Hole
Barrier
Lever
Lever
Barrier Block Assy
Claws
Claws
2.
Peel off the release paper of the Barrier Tape.
DSC-RX100M4
4-23
3.
Install the Ornamental Ring (A) and press it lightly.
Ornamental Ring (A)
Barrier Tapes
Barrier Tapes
Barrier Block Assy
DSC-RX100M4
4-24
Click on the first or last page to see other DSC-RX100M4 (serv.man2) service manuals if exist.