DOWNLOAD Sony DSC-QX30 Service Manual ↓ Size: 6.36 MB | Pages: 41 in PDF or view online for FREE

DSC-QX30

4-11

10. Pull the Flexible Board out of the hole.
11.  Turn the Gear C counterclockwise to set the lens unit in the retracted state, and then remove the Gear C.

Note: Turn the Gear C to the maximum.

 

Hole

Gear C

Flexible Board

Gear C

12. Remove the 3 Group Frame Block Assy and the Core Unit_1 from the Fixed Barrel.

 

Core Unit_1

Fixed Barrel 
Core Unit_1

Fixed Barrel

3 Group Frame Block Assy

DSC-QX30

4-12

13. Remove the Core Unit_2 from the Drive Gear Barrel and Linear Motion Cam Barrel.
14. Turn the Linear Motion Cam Barrel to remove it from the Drive Gear Barrel Assy.

 

Core Unit_2

Linear Motion Cam Barrel

Drive Gear Barrel Assy

Drive Gear Barrel
Linear Motion Cam Barrel

15. Turn the rear edge of Core Unit_3 counterclockwise to extend the Front Assy.

Note:  For removing the Barrier Assy, refer to “(1) Ornamental Ring A or Barrier Assy Replacing Method”.

 

Ornamental Ring A

Rear edge of Core Unit_3

Front Assy

Note
For removing the Ornamental Ring A
and the Barrier Assy, refer to "(1) 
Ornamental Ring A or Barrier Assy

 

Barrier Assy

Replacing Method".

DSC-QX30

4-13

16. Remove the Core Unit_3 from the Front Assy and Linear Guide Barrel_A.

 

Core Unit_3

Linear Guide
Barrel_A

Front Assy

17. Return the Linear Guide Barrel_A to the retracted end.
18. Turn the rear edge of Front Assy about 12 degrees in the direction of arrow to detach the Front Assy from the Linear Guide Barrel_A.

Note:  When detaching the Front Assy, do not stimulate the white part shown below.  If it is stimulated, it may pop out by the action of the spring.

 

About 12
(Approx. 4mm) 

Linear Guide Barrel_A

Linear Guide Barrel_A

Rear edge of Front Assy

Front Assy

Spring

White part

19. Turn the Barrier Frame to remove it from the 1 Group Frame Block Assy.

 

Front Assy

Barrier Frame

1 Group Frame Block Assy

DSC-QX30

4-14

20. Turn the Core Unit_4 in the direction of arrow to detach it.

Note:  Though the Core Unit_4 has resistance due to the spring tension, it can be detached by turning it overcoming the resistance.

 

Cam Barrel

Core Unit_4

21. Unhook the 2G Spring at two locations and remove the 2 Group Frame Block Assy from the Linear Guide Barrel_B.

 

Tweezers

2 Group Frame Block Assy

2 Group Frame Block Assy

Linear Guide Barrel_B

2G Spring

2G Spring