Sony DSC-N2 (serv.man2) Service Manual ▷ View online
2-9
DSC-N2_L2
4
Tighten four screws (#19) in the order of A to D.
* Tightening torque = 0.5 kgf • cm (4.9 N)
3
Put the back body block on the front lens block, taking care of the following points:
Note: 1 Do not pinch the 3 group spring and Z reset sensor by the set.
2 Do not allow the naruto washer and naruto gear to drop off.
3 The flexible cable must be engaged with the ribs of the
3 The flexible cable must be engaged with the ribs of the
back body
block.
4 Do not touch the flexible board etc. to G6 lens.
3 group spring
Flexible cable
Z reset sensor
Confirm whether flexible board hangs in
the rib of the back body block.
the rib of the back body block.
Confirm the flexible board has gone out up.
Confirm abnormality is not found in the state
of the flexible board.
of the flexible board.
Naruto gear,
Naruto washer
Naruto washer
Check the state of the flexible board
G6 lens
A
B
C
D
(#19)
(#19)
(#19)
(#19)
HARDWARE LIST
HARDWARE LIST
2-10
DSC-N2_L2
5
Insert the flexible cable (beware of loose insertion).
Flexible board
Z reset sensor
6
Install the Z reset sensor (press fitting into zoom gear block).
2-11
DSC-N2_L2
2-4-3. INSTALL NEW Z PLATE SPRING
Z plate spring
1
Hook a claw of the Z plate spring on the zoom gear block.
2
Pressing the spring in the arrow direction, engage the part of the Z plate spring in position shown
above.
above.
3
Pressing the spring in the arrow direction, engage two claws of the Z plate spring.
2-12
DSC-N2_L2
2-4-5. INSTALL NEW F PLATE SPRING
Hold the reset P1 sensor with the F plate spring to secure.
1
Hook two claws of the F plate spring on the zoom gear block.
2
Engage two claws of the zoom gear block and F plate spring.
2-4-4. INSTALL NEW 3 GROUP SPRING
Hook the 3 group spring on the front lens block by using the tweezers, etc.
Tweezers etc.
Hook
3 group spring
(Non-replaceable part. Beware of damage.)
(Non-replaceable part. Beware of damage.)
F plate spring
P1 reset sensor
1
2
Click on the first or last page to see other DSC-N2 (serv.man2) service manuals if exist.