Sony XR-C5500T Service Manual ▷ View online
5
HEAT SINK
1
three screws
(PTT2.6
(PTT2.6
×
8)
1
two screws
(PTT2.6
(PTT2.6
×
8)
2
two screws
(PTT2.6
(PTT2.6
×
12)
3
heat sink
6
ARM (SUCTION)
Note:
Follow the assembly procedure in the numerical order given.
HOUSING
SECTION 3
ASSEMBLY OF MECHANISM DECK
A
part
C
part
B
part
D
part
8
Hold the hanger by
bending the claw.
bending the claw.
6
Fit projection on
D
part.
4
Fit claw on
B
part.
3
Put the housing
under
under
A
part.
5
Fit projection on
C
part.
1
Install the catch to the hanger.
2
Install the hanger onto
two claws of the housing.
two claws of the housing.
7
Holder the hanger by bending the claw.
hanger
housing
2
Move the arm (suction) in the arrow
direction and fit on projection.
direction and fit on projection.
1
Fit the arm (suction) on the shaft.
projection
7
shaft
A
shaft
B
2
Fit the lever (LDG-B) on
shafts
shafts
A
and
B
and
install it.
3
type-E stop ring 2.0
LEVER (LDG-A) / (LDG-B)
GEAR (LDG-FT)
shaft
A
shaft
B
shaft
C
1
Fit the lever (LDG-A) on
shafts
shafts
A
–
C
and install it.
gear (LDG-D)
5
gear (LDG-FT)
6
polyethylene washer
2
tension spring (LD-2)
2
tension spring (LD-1)
gear (LDG-FB)
lever (LDG-A)
hole
hole
4
Align hole in the gear (LDG-D)
with hole the lever (LDG-A).
with hole the lever (LDG-A).
3
Move the lever (LDG-B)
in the arrow direction.
in the arrow direction.
1
8
GUIDE (C)
MOUNTING POSITION OF CAPSTAN/REEL MOTOR (M901)
2
guide (C)
1
three claws
two precision screws
(P2
(P2
×
2)
capstan/reel motor
(M901)
(M901)
30˚
Note: Mount the motor so that the
angle between of the
motor and the hole for the
screw becomes 30
motor and the hole for the
screw becomes 30
°
as
shown in this figure.
Click on the first or last page to see other XR-C5500T service manuals if exist.