Sony XR-3750 / XR-3758 / XR-3759 / XR-7750 / XR-C350 / XRS-888 Service Manual ▷ View online
– 13 –
CHASSIS (S) ASS’Y
2 screw (PS2
×
4)
1 chassis (S) ass’y
2 screw (PS2
×
4)
1. Align
¢ mark on the rotary switch with
hole in the lever (mode).
2. Fit on positions A, B and C and install
the lever (mode).
LEVER (MODE)
hole in lever (mode)
¢ mark on rotary switch
lever (mode)
rotary switch
A
C
B
– 14 –
LEVER (PINCH SELECTION)
1 Align.
2 lever (pich selection)
HEAD PLATE ASS’Y
5 step screw (HP)
5 step screw (HP)
2 Fit shaft in groove.
ATS lever
1 Fit in groove.
3 Press the ATS lever.
4 Position the head plate sub
ass’y as shown in the figure.
groove
– 15 –
LEVER (PINCH) ASS’Y
1 Fit shaft of the lever (Pinch) ass’y
in hole on the chassis (M) ass’y and
install the lever (pinch) ass’y.
install the lever (pinch) ass’y.
2 two polyethylene washers
3 Install the spring
(pinch press) to shaft A.
Set the ends of spring to
B and C.
Set the ends of spring to
B and C.
shaft
shaft
B
C
C
B
shaft A
HOUSING
2 Install the hanger on to
two claws of the housing.
1 Install the catch to the hanger.
7 Holder the hanger by bending the claw.
A part
B part
C part
D part
8 Holder the hanger by
bending the claw.
3 Put the housing
under A part.
4 Fit claw on B part.
6 Fit projections on D part.
5 Fit projections on C part.
hanger
– 16 –
ARM (SUCTION)
2 Move the arm (suction) in the arrow
direction and fit on projection.
1 Fit the arm (suction) on the shaft.
projection
1 Fit the lever (LDG-A)
on shaft A – C and install it.
shaft A
shaft B
shaft C
3 two type-E stop ring 2.0
2 Fit the lever (LDG-B)
on shafts A and B and
install.
install.
shaft A
shaft B
LEVER (LDG-A) / (LDG-B)
Click on the first or last page to see other XR-3750 / XR-3758 / XR-3759 / XR-7750 / XR-C350 / XRS-888 service manuals if exist.