DOWNLOAD Sony CDX-C760 / CDX-C760RDS Service Manual ↓ Size: 1.82 MB | Pages: 59 in PDF or view online for FREE

– 21 –

5

 guide (disc)

6

 lever (R) assy

7

 lever (L) assy

1

 PS 2x4

2

 DISC IN SW board

4

 claws

2

 P 2x3

3

 chassis (T) sub assy

1

 P 2x3

3

 tension spring (LR)

– 22 –

• When installing, take note of the positions
  arm (roller) and washers. (Fig. 1)

2

 arm (roller)

3

 roller assy

Fig. 1

2

 PS 2x5

3

 PS 2x5

8

 CN2

6

 P 2x3

!º

 CN4

!™

 SERVO board

5

 CN6

1

 PS 2x4

7

 loading motor assy

9

 CN5

4

 heat sink

4

 PS 2x3

5

 LOAD SW board

1

 tension spring (RA)

arm

washers

washer

arm washer

!¡

 PS 2x4

– 23 –

5

Turn loading ring in the
direction of the arrow.

2

 damper (T)

3

 damper (T)

4

Fit lever (D) in the
direction of the arrow.

3

 optical pick-up block

1

 P 2x3

2

 sled motor assy

8

 compression spring (FL)

1

 tension spring (angle)

6

 chassis (OP) (O/S) assy

7

 compression spring (FL)

– 24 –

Carrier frequency : 97.9 MHz (C760)

: 98.00 MHz (C760RDS)

Output level

: 22 dB (12.6 µV)

Mode

: mono

Modulation

: 1 kHz, 22.5 kHz deviation (30%)

Procedure :
1. Set to the test mode.
2. Push the  SOURCE  button and set to FM.

Display

SOURCE button : FM

3. Push the preset  3  button.

Display

4. Adjust with the volume RV2 on TU1 so that the “FM”

indication turns to “FM0” indication on the display window.
But, in case of already indicated “FM0”, turn the RV2 so that put
out light “0” indication and adjustment.

Display

FM RF signal

generator

0.01 µF

antenna
terminal

set

CD section adjustments are done automatically in this set.

When the tuner unit is defective, replace it by a new one because
its internal block is difficult to repair.

This set have the test mode function. In the test mode, FM Auto Scan/
Stop Level and AM (MW) Auto Scan/Stop Level adjustments can be
performed easier than it in ordinary procedure.

<Set the Test Mode>
1. Set the “OFF” mode.
2. Push the preset  4  button.
3. Push the preset  5  button.
4. Press the preset  1  button for more than two seconds.
5. Then the display indicates all lights, the test mode is set.

<Release the Test Mode>
1. Push the  OFF  button.

The adjustments of tuner section, should be performed according to
the following sequence.
1. FM Auto Scan/Stop Level Adjustment
2. FM Stereo Separation Adjustment
3. FM RDS S-Meter Adjustment (CDX-C760RDS only)
4. AM (MW) Auto Scan/Stop Level Adjustment

REG

SHUF1

REG

SHUF1

*1 : “REG” is displayed only for CDX-C760RDS.
*2 : CDX-C760RDS has the “98.00” displayed.

Adjustment Location : See page 26.

REG

SHUF1

*

1

*

2

*

1

*

2

*

1

*

2