Sony CCD-CR1 / CCD-CR1E (serv.man2) Service Manual ▷ View online
2-6
2-8. SERVICE POSITION-1 (Mainly for adjustment, check or voltage measurement-1)
Firstly, remove the following parts referring DISASSEMBLY (sections 2-1 and 2-7), and connect parts as shown below.
Regulated DC
power supply
(DC +3 V)
power supply
(DC +3 V)
Power supply cord jig
(J-6082-415-A)
VC-205 board (CN801)
(J-6082-415-A)
VC-205 board (CN801)
Fully close the
battery case.
battery case.
CD-191 board
Lens unit
MJ-88 board
Adjustment remote
commander RM-95
Regulated DC power supply
(DC +5 V)
(DC +5 V)
CPC 11 jig (J-6082-425-A)
VC-205 board (CN152)
VC-205 board (CN152)
Cabinet (rear) assembly
VC-205
BO
BO
ARD
2-7
2-9. SERVICE POSITION-2 (For voltage measurement-2)
Firstly, remove the following parts referring DISASSEMBLY (sections 2-1, 2-2, 2-3, and 2-7), and connect parts as shown below.
Regulated DC power supply
(DC +3 V)
(DC +3 V)
Fix the battery case OPEN/CLOSE
sensor switch to the "ON" position
with adhesive tape.
sensor switch to the "ON" position
with adhesive tape.
POWER ON/OFF switch
Cabinet (upper) assembly
CD-191 board
MJ-88 board
Cabinet (rear) assembly
Cartridge
VC-205 board
Power supply cord jig
(J-6082-415-A)
VC-205 board (CN801)
(J-6082-415-A)
VC-205 board (CN801)
Extension jig (J-6082-426-A)
VC-205 board (CN101)
VC-205 board (CN101)
2-8E
2-10.CIRCUIT BOARDS LOCATION
VC-205
TIMING GENERATOR, Y/C PROCESSOR, REC/PB HEAD AMP,
D/A CONVERTER, MODE CONTROL, SERVO/SYSTEM CONTROL,
SERVO, DRUM/REEL PWM DRIVE
TIMING GENERATOR, Y/C PROCESSOR, REC/PB HEAD AMP,
D/A CONVERTER, MODE CONTROL, SERVO/SYSTEM CONTROL,
SERVO, DRUM/REEL PWM DRIVE
FP-685
(VC-205—BATTERY TERMINAL CONNECTOR)
CD-191
(CCD IMAGER)
(CCD IMAGER)
MJ-88
(AUDIO REC/PB AMP)
(AUDIO REC/PB AMP)
CONTROL SWITCH BLOCK
LCD PANEL
PD-99
RGB DRIVER, TIMING GENERATOR,
SP AUDIO AMP
RGB DRIVER, TIMING GENERATOR,
SP AUDIO AMP
FP-686
(PD-99—VC-205 CONNECTOR)
CCD-CR1/CR1E
SECTION 3
BLOCK DIAGRAMS
3-1. OVERALL BLOCK DIAGRAM
3-1
3-2
3-3
3-4
Click on the first or last page to see other CCD-CR1 / CCD-CR1E (serv.man2) service manuals if exist.