DOWNLOAD Sony TAV-L1 (serv.man3) Service Manual ↓ Size: 15.24 MB | Pages: 127 in PDF or view online for FREE

41

To  check the version information, please follow the following
procedure.
Procedure:

1. From the top menu of  Remocon Diagnosis Menu, select “4.

Version Information” by pressing the [4] button on the remote
commander. The following screen appears on the on-screen
display.

Version information

Firm(Main): Ver. X.XXXX

Firm(Sub): XX.XX

RISC: XXXXXX

8032: XXXXXX

Audio DSP: XX.XX.XX.XX

Servo DSP: XX.XX.XX.XX

[0]Return to Top Menu

2. To return to the top menu of Remocon Diagnosis Menu, press

the [0] on the remote commander.

42

• Confirm the gap between the effective screen of LCD block and DVD block opening within specification.

• In adjusting the DVD block, prepare jig (Part. No. J-2501-298-A ECCENTRIC SCREWDRIVER).

Difference between A and B within 2 mm.

Position of adjust.

LCD block

Loose screw of 
the right hole.

Tighten screw of right side without remove eccentric screwdriver of adjust.
After remove eccentric screwdriver of adjust, tighten screw of left side.

Fix eccentric
screwdriver of adjust.

Turn eccentric screwdriver of adjust and adjust top.

Loose screw of the left hole.

DVD block

– FRONT VIEW –

43

• Confirm the bend of LCD block and gap between DVD block and LCD block within specification.

• Confirm the gap of LCD block and DVD block within the specification.

Dimension C  less than 5.5 mm.

Position D is check from MP.

Check by test pin diameter 5.5 mm.

DVD block

LCD block

– TOP VIEW –

E: 2 to 5 mm

F: 2 to 5 mm

LCD block

DVD block

– SIDE VIEW –

44

Aging mode is designed to remove image retention from the screen.

 Once you enter into aging mode the remote commander no longer

functions with the set. To turn off the set, press the [POWER] button
on the set.

1. Set the service mode.
2. Select the “SVC”.

3. Set the “AGING MODE” to the “ON”.

1. Set the remote commander (RM-ANP003) to the MONITOR

mode.

2. Press the [POWER] button to turn off sleep mode.
3. Press the [POWER] button to set the standby mode.
4. Press the following buttons on the remote commander within

a second of each other.

[DISPLAY]

 → [5] → [VOL +] → [POWER]

5. When service mode is activated, it is displayed as follows.

The TEST RESET option resets all the customer adjustable data
back to factory defaults.

 These sets have a sleep mode. To turn the sleep mode off, turn the set

on and access service mode within two minutes.

1. Set the service mode.
2. Select the “SVC”.

3. Set the “TEST RESET” to the “OK”.