Sony ICF-CD513 (serv.man2) Service Manual ▷ View online
9
ICF-CD513
5-2. CD MECHANISM DECK SECTION
(FLM-CD513-149)
Ref. No.
Part No.
Description
Remark
Ref. No.
Part No.
Description
Remark
501
3-028-010-02 TRAY
502
3-028-019-02 PLATE, CHUCK
503
1-452-899-21 MAGNET
504
3-713-786-51 SCREW (M2X3)
505
3-028-014-01 GEAR
506
3-028-015-01 PULLEY
507
3-933-020-01 BELT
508
3-921-725-11 SCREW (2.6X10), +PWH
* 509
3-028-009-12 CHASSIS
510
3-028-013-01 GEAR, DRIVE
* 511
1-689-833-11 LOADING BOARD
M480
A-3320-538-A MOTOR ASSY, LOADING
#10
7-685-134-19 SCREW +P 2.6X8 TYPE2 NON-SLIT
not supplied
not supplied
#10
not supplied
503
502
501
511
510
508
509
508
507
506
505
504
M480
base unit section
10
ICF-CD513
5-3. BASE UNIT SECTION
(FLM-CD513-149)
Ref. No.
Part No.
Description
Remark
Ref. No.
Part No.
Description
Remark
551
3-921-725-01 SCREW (2.6X10), +PWH
552
3-910-095-31 RUBBER, VIBRATION PROOF (GREEN)
553
3-028-011-01 ARM
554
3-910-095-21 RUBBER, VIBRATION PROOF (RED)
553
554
554
552
552
551
optical section
(KSM-213RCP)
(KSM-213RCP)
11
ICF-CD513
5-4. OPTICAL BLOCK
(KSM-213RCP)
Ref. No.
Part No.
Description
Remark
Ref. No.
Part No.
Description
Remark
601
X-2162-708-1 CHASSIS ASSY (RCP) (RP),
MOTOR (including M591)
* 602
2-647-408-02 GEAR (B)
* 603
2-169-065-01 GEAR (A)
604
2-169-388-01 TAPPING (M2), +PWB
0 605
8-820-161-02 OPTICAL PICK-UP (KSS-213R/C2RP)
606
2-626-908-01 SHAFT, SLED
607
3-713-786-51 SCREW (M2X3)
M592
X-2162-712-1 GEAR ASSY (R) (RP), MOTOR (SLED)
602
603
605
606
601
607
604
M592
The components identified by
mark 0 or dotted line with
mark 0 are critical for safety.
Replace only with part num-
ber specified.
mark 0 or dotted line with
mark 0 are critical for safety.
Replace only with part num-
ber specified.
Les composants identifiés par une
marque 0 sont critiques pour la
sécurité.
Ne les remplacer que par une pièce
portant le numéro spécifié.
marque 0 sont critiques pour la
sécurité.
Ne les remplacer que par une pièce
portant le numéro spécifié.
12
ICF-CD513
6.
ELECTRICAL PARTS LIST
LOADING
Ref. No.
Part No.
Description
Remark
Ref. No.
Part No.
Description
Remark
*
1-689-833-11 LOADING BOARD
**************
<CAPACITOR>
C708
1-127-888-21 CERAMIC CHIP
0.1uF
10%
50V
<CONNECTOR>
* CN701
1-695-107-11 PIN, CONNECTOR (PC BOARD) 5P
<COIL>
L702
1-412-852-11 INDUCTOR
47uH
L703
1-412-852-11 INDUCTOR
47uH
<SWITCH>
S701
1-771-489-11 SWITCH, LEVER SLIDE
(TRAY OPEN/CLOSE DETECT)
************************************************************
MISCELLANEOUS
**************
**************
13
1-769-824-11 WIRE (FLAT TYPE) (16 CORE)
16
1-786-017-11 SWITCH, RUBBER KEY
503
1-452-899-21 MAGNET
601
X-2162-708-1 CHASSIS ASSY (RCP) (RP), MOTOR
(including M591)
0 605
8-820-161-02 OPTICAL PICK-UP (KSS-213R/C2RP)
C708
1-164-159-21 CERAMIC
0.1uF
50V
M480
A-3320-538-A MOTOR ASSY, LOADING
M592
X-2162-712-1 GEAR ASSY (R) (RP), MOTOR (SLED)
S591
1-571-936-11 SWITCH, LEAF (LIMIT)
NOTE:
• Due to standardization, replacements in the
parts list may be different from the parts speci-
fied in the diagrams or the components used
on the set.
fied in the diagrams or the components used
on the set.
• -XX and -X mean standardized parts, so they
may have some difference from the original
one.
one.
• RESISTORS
All resistors are in ohms.
METAL: Metal-film resistor.
METAL OXIDE: Metal oxide-film resistor.
F: nonflammable
METAL: Metal-film resistor.
METAL OXIDE: Metal oxide-film resistor.
F: nonflammable
• Items marked “*” are not stocked since they
are seldom required for routine service.
Some delay should be anticipated when order-
ing these items.
Some delay should be anticipated when order-
ing these items.
• SEMICONDUCTORS
In each case, u:
µ, for example:
uA. .
:
µA. .
uPA. . :
µPA. .
uPB. . :
µPB. .
uPC. . :
µPC. .
uPD. . :
µPD. .
• CAPACITORS
uF:
µF
• COILS
uH:
µH
Les composants identifiés par une
marque 0 sont critiquens pour la
sécurité.
Ne les remplacer que par une pièce
portant le numéro spécifié.
marque 0 sont critiquens pour la
sécurité.
Ne les remplacer que par une pièce
portant le numéro spécifié.
The components identified by
mark 0 or dotted line with mark
mark 0 or dotted line with mark
0 are critical for safety.
Replace only with part number
specified.
Replace only with part number
specified.
When indicating parts by reference
number, please include the board.
number, please include the board.