Sony HCD-ECL5 Service Manual ▷ View online
HCD-ECL5
9
2-5. FRONT PANEL BLOCK
2-4. CD DOOR
3 four claws
– Rear view –
1 Turn the traverse gear in
the direction of an arrow.
bottom side
top side
– Rear view –
4 CD door
2 Pull out the disc tray.
4 two claws
5 front panel block
– Rear right view –
Wire setting
MAIN board
front panel block
4 two claws
3 connector
(XP15)
2 connector
(XP7)
1 connector
(XP19)
– Right view –
resistor
Note: When installing the wire,
be careful not to touch
the
resistor.
HCD-ECL5
10
2-6. MAIN BOARD BLOCK
2-7. MAIN BOARD
5 Solder the short-land.
Note 2: When assembling the MAIN board block,
remove the solder of short-land after
connecting all flexible flat cable
and
connector.
3 two claws
2 connector
(XP4)
6 flexible flat cable
(XP3)
7 MAIN board block
4 Lift the MAIN board block
in the direction of an arrow.
1 connector (XP5)
Note
3: Since the wire is very thin, it is easy to cut.
When disconnecting, do it while holding the
connector
part.
3 two claws
3 four claws
Note 1: Before disconnecting the flexible flat cable of the loader with FFC (TDL-5) (CDM1), solder the short-land.
7 MAIN board
2 connector
(XP20)
6 heatsink
1 connector
(XP1)
5 two heat sink
screws
(3
(3
u 8)
– Rear right view –
3 screw
(silver
3
u 8)
3 screw
(silver
3
u 8)
4 Remove the MAIN board block
in the direction of an arrow.
HCD-ECL5
11
2-8. POWER BOARD
– Rear view –
2 connector
(XP20)
0 power board
9 Draw out the
wires.
8 Remove the power board
in the direction of an arrow.
7 two screws
(silver
3
u 8)
7 two screws
(silver
3
u 8)
1 connector
(XP1)
6 shield cover
5
– Rear view –
4 five claws
4 claw
3 screw
(3
u 6)
HCD-ECL5
12
2-9. FRONT BOARD
4 two claws
– Front panel block rear view –
FRONT board
Wire setting
– Front panel block rear view –
FRONT board
Wire setting
– Front panel block rear view –
2 two screws
(silver
3
u 8)
2 two screws
(silver
3
u 8)
3 ground plate
5 FRONT board
1 VOL knob
(black)
2 screw
(silver
3
u 8)
2 screw
(silver
3
u 8)
Click on the first or last page to see other HCD-ECL5 service manuals if exist.