Sony CMT-X3CD (serv.man2) Service Manual ▷ View online
CMT-X3CD
9
2-3. LOADER BLOCK
2 Remove the loader block in
the direction of the arrow.
1 four screws
(6)
4 connector
(XP4)
3 Peel off the
adhesive
sheet.
5 flexible flat cable (24P)
(XP3)
6 flexible flat cable (5P)
(XP5)
7 loader block
– Front bottom view –
colored line
Insert straight into the interior.
flexible flat
cable
cable
connector
OK
colored line
Insert at a slant.
flexible flat
cable
cable
connector
NG
Note: When installing the flexible flat cable,
ensure that the colored line is parallel
to the connector after insertion.
CMT-X3CD
10
2-4. LOADER ASSY (CDM1), OPU ASSY (OP1)
1 four screws
(5)
3 vibration proof rubber
3 vibration proof rubber
3 vibration proof rubber
3 vibration proof rubber
4 loader cover
6 two screws
8 four screws
9 OPU assy
(OP1)
0 loader assy
(CDM1)
7 OPU FFC block
5 OPU wire assy
(WR1)
– Loader block bottom view –
colored line
Insert straight into the interior.
flexible flat
cable
cable
connector
OK
colored line
Insert at a slant.
flexible flat
cable
cable
connector
NG
Note: When installing the flexible flat cable, ensure that
the colored line is parallel to the connector after insertion.
2 Remove the loader block in
the direction of the arrow.
CMT-X3CD
11
2-5. MA BOARD, NFC MODULE
5 connector
(XP8)
8 four screws
(5)
9 MA board
qd NFC module
1 flexible flat cable (10P)
(XP18)
7 connector
(XP1)
2 connector
(XP6)
4 flexible flat cable (10P)
(XP17)
3 connector
(XP7)
6 flexible flat cable (8P)
(XP12)
– Front bottom view –
colored line
Insert straight into the interior.
flexible flat
cable
cable
connector
OK
colored line
Insert at a slant.
flexible flat
cable
cable
connector
NG
qa Insert the tweezers in the crevice between
the NFC module and the top panel,
and lift the NFC module.
0 connector
(XP11)
qs Remove the NFC module in
the direction of the arrow.
top panel
adhesive sheet
tweezers
NFC module
Note 2: When installing the flexible flat cable,
ensure that the colored line is parallel
to the connector after insertion.
Note 1: When replacing the MA board or the NFC module, be sure
replace both at the same time. The MA board or the NFC mod-
ule cannot replace with single.
ule cannot replace with single.
CMT-X3CD
12
2-6. KY BOARD
– Front bottom view –
colored line
Insert straight into the interior.
flexible flat
cable
cable
connector
OK
colored line
Insert at a slant.
flexible flat
cable
cable
connector
NG
Note: When installing the flexible flat cable,
ensure that the colored line is parallel
to the connector after insertion.
3 two screws
(6)
5 KY board
4
flexible flat cable (10P)
(XP7)
1
connector
(XP18)
2
connector
(XP11)
Ver. 1.1
Click on the first or last page to see other CMT-X3CD (serv.man2) service manuals if exist.