Sony CMT-HPZ7 / CMT-HPZ9 / HCD-HPZ7 / HCD-HPZ9 Service Manual ▷ View online
45
HCD-HPZ7/HPZ9
3-8. ASSEMBLING OF THE LEVER (SUB GEAR BACK L)
1
Turn over the stocker assy
in the direction of the arrow.
2
Adjust phases.
gear (stock rotary left)
gear (sub gear pin left)
3
gear (sub gear pin left)
4
washers (5.5)
qa
k tapping screw
(2.6
×
8)
0
screw (M2
×
5)
9
cover (L)
7
lever
(sub gear back L)
8
SPR-T
(sub gear back L)
SPR-T (sub gear back L)
gear (stock rotary left)
sub gear (joint just front)
6
lever (joint just front)
gear (sub gear pin left)
5
gear (stock joint),
shaft (stock)
lever (sub gear back L)
PRECAUTION DURING SPR-T
(SUB GEAR BACK L) INSTALLATION
(SUB GEAR BACK L) INSTALLATION
PRECAUTION DURING GEAR
(SUB GEAR PIN LEFT) INSTALLATION
(SUB GEAR PIN LEFT) INSTALLATION
UPPER
SIDE
SIDE
46
HCD-HPZ7/HPZ9
3-9. ASSEMBLING OF THE GEAR (SUB GEAR PIN RIGHT)
1
Turn over the stocker assy
in the direction of the arrow.
2
Remove the arm (R)
in the direction of the arrow.
4
two screws
(2
×
5)
3
two dowels
6
Adjust phases.
gear (sub gear pin right)
gear (stock rotary right)
gear (stock joint)
7
washer (5.5)
5
gear (sub gear pin right)
PRECAUTION DURING GEAR
(SUB GEAR PIN RIGHT) INSTALLATION
(SUB GEAR PIN RIGHT) INSTALLATION
UPPER
SIDE
SIDE
47
HCD-HPZ7/HPZ9
3-10. ASSEMBLING OF THE LEVER (SUB GEAR BACK R)
SPR-T (sub gear back R)
gear (stock rotary right)
lever (sub gear back R)
gear (sub gear pin right)
claw
2
gear (stock joint)
1
sub (joint just front)
Note:
Put the driver on the bottom of the other side of the gear,
and push the gear (stock joint) into it. Confirm it is
attached securely.
Put the driver on the bottom of the other side of the gear,
and push the gear (stock joint) into it. Confirm it is
attached securely.
4
lever (sub gear back R)
5
SPR-T (sub gear back R)
3
claw
PRECAUTION DURING SPR-T
(SUB GEAR BACK R) INSTALLATION
(SUB GEAR BACK R) INSTALLATION
48
HCD-HPZ7/HPZ9
3-11. ASSEMBLING OF THE SUB GEAR (IDLER)
3
sub gear (idler)
sub slider assy
1
Push the sub slider assy in the direction
of the arrow
A
until it stops.
4
Position to adjust phases
for the sub gear (idler).
5
three sub gears (idler)
A
Note.
The side which has a pattern is the bottom.
No need of phase adjustment.
The side which has a pattern is the bottom.
No need of phase adjustment.
Note.
The side which has a pattern is the bottom.
The side which has a pattern is the bottom.
2
The place that the sub slider assy
stops outside of this.
Click on the first or last page to see other CMT-HPZ7 / CMT-HPZ9 / HCD-HPZ7 / HCD-HPZ9 service manuals if exist.