Sharp LC-37D65 Handy Guide ▷ View online
Firmware Upgrade Procedure
Version 1.0
Issue 07/2010
13
SHARP ELECTRONICS (UK) LTD
CE TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
6. When all the procedures are complete, the following upgrade success screen shows
up. The new software version can be confirmed on screen.
The version number appears when each item has been successfully upgraded. Finally
the main version number appears on screen.
The version number appears when each item has been successfully upgraded. Finally
the main version number appears on screen.
7. Turn off the AC power (Unplug the AC power cord). Take out the upgrading USB flash
memory.
It waits for about 20 seconds until the AC power supply is turned off.
It waits for about 20 seconds until the AC power supply is turned off.
8. Now the software has been upgraded.
NOTE: Then get the set started and call the process adjustment screen 1/16 to
check the main software version.
check the main software version.
CAUTION:
1) Do not take out and put in the USB flash memory during formatting.
2) It takes about one minute to the rewriting completion.
Please confirm the upgrade status on the screen becomes 100%.
3) The AC power supply of the set is waited for about 20 seconds until off (The
AC outlet is pulled out) after the upgrade is completed.
1) Do not take out and put in the USB flash memory during formatting.
2) It takes about one minute to the rewriting completion.
Please confirm the upgrade status on the screen becomes 100%.
3) The AC power supply of the set is waited for about 20 seconds until off (The
AC outlet is pulled out) after the upgrade is completed.
Unit Rest Procedures
Version 1.0
Issue 07/2010
14
SHARP ELECTRONICS (UK) LTD
CE TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Entering and exiting the adjustment process mode
1. Unplug the AC power cord of running TV set to force off the power.
2.
While holding down the “VOL (-)” and “INPUT” keys on the set at once, plug in the AC
power cord to turn on the power.
The letter “K” appears on the screen.
power cord to turn on the power.
The letter “K” appears on the screen.
3.
Next, hold down the “VOL (-)” and “P (DOWN)” keys on the set at once.
Multiple lines of blue characters appearing on the screen indicate that the set is now
in the adjustment Process mode.
If you fail to enter the adjustment process mode (the display is the same as normal
startup), retry the procedure.
Multiple lines of blue characters appearing on the screen indicate that the set is now
in the adjustment Process mode.
If you fail to enter the adjustment process mode (the display is the same as normal
startup), retry the procedure.
4. To exit the adjustment process mode after the adjustment is done, unplug the AC
power cord to force off the power. (When the power is turned off with the remote
controller, once unplug the AC power cord and plug it in again. In this case, wait 10
seconds or so before plugging.)
controller, once unplug the AC power cord and plug it in again. In this case, wait 10
seconds or so before plugging.)
Product Dimensions
Version 1.0
Issue 07/2010
15
SHARP ELECTRONICS (UK) LTD
CE TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Dimensions LC-32D65E () / LC-37D65E [ ]
Product Dimensions
Version 1.0
Issue 07/2010
16
SHARP ELECTRONICS (UK) LTD
CE TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Dimensions LC-32D65E () / LC-37D65E [ ]
Click on the first or last page to see other LC-37D65 service manuals if exist.