Sharp LC-32SB25EB (serv.man2) User Manual / Operation Manual ▷ View online
appendix
problem
possible Solution
No picture
1� Connect power cord correctly�
2� Turn on power�
3� Connect signal cable correctly�
4� Press any button on the LCD TV�
2� Turn on power�
3� Connect signal cable correctly�
4� Press any button on the LCD TV�
Abnormal colours
Connect signal cable correctly�
Twisted picture
1� Connect signal cable correctly�
2� Please use compatible signal�
2� Please use compatible signal�
Picture too dark
Adjust brightness and contrast�
Audio only, no images
1� Please check if input signal is connected correctly�
2� TV-RF signal must not be lower than 50dB�
2� TV-RF signal must not be lower than 50dB�
Picture only, no audio
1� Connect signal cable correctly�
2� Adjust volume to proper level�
3� Connect audio signal cable correctly�
4� TV-RF signal must not be lower than 50dB�
2� Adjust volume to proper level�
3� Connect audio signal cable correctly�
4� TV-RF signal must not be lower than 50dB�
Cannot use remote control
1� Please change battery�
2� Turn off power for 10 seconds; and then restart power�
2� Turn off power for 10 seconds; and then restart power�
Cannot receive sufficient channels
through antenna
through antenna
Please use the Channel scan function to increase the number of
channels not included in memory�
channels not included in memory�
No colours
Please adjust the colour setup�
Blinking picture accompanied by ghost
image
image
1� Check the connection of antenna/signal cable�
2� Check if channel is in play mode�
3� Press signal source and change input mode�
2� Check if channel is in play mode�
3� Press signal source and change input mode�
Broken lines or segments
Adjust antenna�
Keep the TV away from noise sources, such as automobiles, neon
lights, and hair dryers�
Keep the TV away from noise sources, such as automobiles, neon
lights, and hair dryers�
Certain TV channels are blocked (Hope to
acquire some channels)
acquire some channels)
Please use the Update scan method to add the channels not
included in memory�
included in memory�
Overlapping images or ghost images
Please use multi-directional outdoor antenna�
(If your TV is subject to the influence of nearby mountains or
buildings)�
(If your TV is subject to the influence of nearby mountains or
buildings)�
Cannot use a function
If the item you choose turns gray, that item cannot be selected�
Cannot receive programs
Please use the Update scan method to add the channels not
included in memory�
included in memory�
troubleshooting
27
appendix
item
26o lCD Colour tV,
model: lC-26SB25e,
lC-26SB25S
lC-26SB25S
32o lCD Colour tV,
model: lC-32SB25e,
lC-32SB25S
lC-32SB25S
42o lCD Colour tV,
model: lC-42SB55e,
lC-42SB55S
lC-42SB55S
LCD screen size
26o diagonal
32o diagonal
42o diagonal
Number of dots
3,147,264 dots
(1366 g 768 g 3 dots)
(1366 g 768 g 3 dots)
3,147,264 dots
(1366 g 768 g 3 dots)
(1366 g 768 g 3 dots)
6,220,800 dots
(1920 g 1080 g 3 dots)
(1920 g 1080 g 3 dots)
Video Colour System
PAL/SECAM/NTSC 3.58/NTSC 4.43/PAL 60
TV Function
TV-Standard
Analogue
CCIR (B/G, I, D/K, L/L’)
Digital
DVB-T
(2K/8K OFDM)
Receiving
Channel
Channel
VHF/UHF
ATV : IRA-E69, DVB-T : E5-E69
CATV
S-band, S1–S41ch
TV-Tuning System
Auto Preset 999 ch, Auto Label, Auto Sort
STEREO/BILINGUAL
NICAM/A2
Brightness
500 cd/m
2
450 cd/m
2
500 cd/m
2
Backlight life
60,000 hours (at Backlight Standard position)
Viewing angles
H : 160° V : 150°
H : 176° V : 176°
Audio amplifier
5W g 2
5W g 2
10W g 2
Speaker
(100 mm g 30 mm) g 2
(100 mm g 30 mm) g 2
(140 mm g 30 mm) g 2
Rear
Side
Antenna
UHF/VHF 75 q
RS-232C
D-Sub 3 pin male connector
SCART 1
SCART (AV input, Y/C input, RGB input, TV output-analogue only)
SCART 2
SCART (AV input, Y/C input, monitor output (analogue source - RF, SCART 1, SIDE AV; digital
source - DTV sound only) )
source - DTV sound only) )
PC IN
VGA pin (AV input), Ø 3.5mm jack (Audio input)
Component
Y/Pb(Cb)/Pr(Cr), RCA pin (L/R)
SPDIF
Digital audio output
AUDIO OUT
RCA pin (L/R)
HDMI 1
HDMI 2
C. I. (Common Interface)
EN50221, R206001
Headphones
Ø 3.5mm jack (Audio output)
AV IN
RCA pin (AV input) , RCA pin (L/R), S-VIDEO (Y/C input)
HDMI 3
For 32” and 42” only
OSD language
Bulgarian, Croatian, Czech, Danish, Dutch, English, Finnish, French, German, Greek, Hungarian,
Italian, Norwegian, Polish, Portuguese, Romanian, Russian, Serbian, Slovak, Slovene, Spanish,
Swedish, Turkish
Italian, Norwegian, Polish, Portuguese, Romanian, Russian, Serbian, Slovak, Slovene, Spanish,
Swedish, Turkish
Power Requirement
AC 220–240 V, 50 Hz
Power Consumption
100W (Standby<1W)
(Method IEC60107)
(Method IEC60107)
150 W (Standby<1W)
(Method IEC60107)
(Method IEC60107)
220 W (Standby<1W)
(Method IEC60107)
(Method IEC60107)
Weight
7.8 kg (Without stand),
9.6 kg (With stand)
9.6 kg (With stand)
10.7 kg (Without stand),
12.5 kg (With stand)
12.5 kg (With stand)
19.5 kg (Without stand),
22.7 kg (With stand)
22.7 kg (With stand)
Operating temperature
0°C to k40°C
As a part of policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement
•
without prior notice� The performance specification figures indicated are nominal values of production units� There may be some deviations
from these values in individual units�
from these values in individual units�
note
Refer to the inside back cover for dimensional drawings�
•
Audio cannot be output through the HDMI terminal�
•
Specification
28
Cautions regarding use in high and low temperature environments
When the unit is used in a low temperature space (e�g� room, office), the picture may leave trails or appear slightly delayed� This
•
is not a malfunction, and the unit will recover when the temperature returns to normal�
Do not leave the unit in a hot or cold location� Also, do not leave the unit in a location exposed to direct sunlight or near a
Do not leave the unit in a hot or cold location� Also, do not leave the unit in a location exposed to direct sunlight or near a
•
heater, as this may cause the cabinet to deform and the LCD panel to malfunction�
Storage temperature:
Storage temperature:
•
e5°C to e35°C�
appendix
information on the software license for this product
Software composition
The software included in this product is comprised of various software components whose individual copyrights are
held by SHARP or by third parties�
Software developed by SHarp and open source software
The copyrights for the software components and various relevant documents included with this product that
were developed or written by SHARP are owned by SHARP and are protected by the Copyright Act, international
treaties, and other relevant laws� This product also makes use of freely distributed software and software
components whose copyrights are held by third parties� These include software components covered by a GNU
General Public License (hereafter GPL), a GNU Lesser General Public License (hereafter LGPL) or other license
agreement�
treaties, and other relevant laws� This product also makes use of freely distributed software and software
components whose copyrights are held by third parties� These include software components covered by a GNU
General Public License (hereafter GPL), a GNU Lesser General Public License (hereafter LGPL) or other license
agreement�
obtaining source code
Some of the open source software licensors require the distributor to provide the source code with the executable
software components� GPL and LGPL include similar requirements� For information on obtaining the source code
for the open source software and for obtaining the GPL, LGPL, and other license agreement information, visit the
following website:
for the open source software and for obtaining the GPL, LGPL, and other license agreement information, visit the
following website:
http://www�sharp-eu�com/gpl/
We are unable to answer any questions about the source code for the open source software� The source code for
the software components whose copyrights are held by SHARP is not distributed�
acknowledgements
The following open source software components are included in this product:
• linux kernel • modutils • glibc • zlib • libpng
“HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of
•
HDMI Licensing LLC�”
The “HD ready” Logo is a trademark of EICTA�
•
The DVB logo is the registered trademark of the Digital Video Broadcasting - DVB - project�
•
other information
trademarks
29
a� information on Disposal for users (private households)
1� in the european union
Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!
2� in other Countries outside the eu
If you wish to discard this product, please contact your local authorities and ask for the correct
method of disposal.
method of disposal.
B� information on Disposal for Business users
1� in the european union
If the product is used for business purposes and you want to discard it:
Please contact your SHARP dealer who will inform you about the take-back of the product. You
might be charged for the costs arising from take-back and recycling. Small products (and small
amounts) might be taken back by your local collection facilities.
might be charged for the costs arising from take-back and recycling. Small products (and small
amounts) might be taken back by your local collection facilities.
2� in other Countries outside the eu
If you wish to discard of this product, please contact your local authorities and ask for the correct
method of disposal.
method of disposal.
For Switzerland: The used battery is to be returned to the selling point.
For other non-EU countries: Please contact your local authority for correct method of disposal of the
used battery.
used battery.
30
