DOWNLOAD Sharp XV-Z1E Service Manual ↓ Size: 740.03 KB | Pages: 42 in PDF or view online for FREE

1-1. Remove the three screws at the carrying handle side.

1-2. Remove the two screws at the terminals side.
1-3. Detach the terminal door, and remove the four screws off the terminal cover.
1-4. Slowly lift the back of the top cabinet and disconnect the operation key unit connector (KY).  Pull up and away

the top cabinet.

1-5. Place the top cabinet upside down.  Remove the four screws off the operation key unit.  Take out the operation

key unit.

1-1

1-2

1-4

1-3

1-2

(KY)

Terminal Door

Top Cabinet

2-1. Tilt the front-right cabinet forward.  Pull it up out of position.
2-2. Tilt the front-left cabinet forward.  Disconnect the infrared R/C receiver unit.  Pull up the cabinet out of position.

2-2

2-1

Front-right Cabinet

Infrared R/C Receiver Unit

Front-left Cabinet

3-1. Remove the two screws off the rear cabinet and the screw from the static ground lead.  Pull  up the cabinet

and disconnect the speaker connector (SP). Now the rear cabinet is free.

3-2. Remove the four screws off the video terminal cover.  Detach the cover.

a

b

3-1

(SP)

Boss

Make sure the bimetal lead terminals are at the bottom
of the boss  a  and rib  b .

Rib

Rear Cabinet

4-1. Remove the two screws that fix the PC terminal cover to the bottom cabinet.
4-2. Remove the two screws off the output shield.  Take out the output shield and disconnect the R-LCD, G-LCD

and B-LCD connectors (RP, GP, and BP).

4-3. Remove the four screws off the output unit.  Disconnect the insulating barrier, the ground leads and the

connectors (FN, Q, LL, FF, LF, BL, RC and EA). Pull up and away the output unit and the signal/Video Input
terminal unit.

4-4. Remove the screw off the back of the output unit.  Separate this unit from the signal/PC terminal unit.
4-5. Remove the screw off the bottom cabinet and the screw off the power panel.  Now take out the power panel.

4-1

4-1

4-3

4-3

4-2

4-4

4-1

4-5

Insulating
Barrier

Output Unit

Signal/Video Input
terminal Unit

Video Input Terminal Cover

Power Panel

Output Shield