DOWNLOAD Sharp XG-NV1E (serv.man4) Service Manual ↓ Size: 872.68 KB | Pages: 21 in PDF or view online for FREE

3-1. Remove the two screws off the rear cabinet and the screw from the static ground lead.  Pull  up the cabinet

and disconnect the speaker connector (SP). Now the rear cabinet is free.

3-2. Remove the four screws off the video terminal cover.  Detach the cover.

(SP)

3-1

3-2

a

b

Make sure the bimetal lead terminals are at the bottom

of the boss  a  and rib  b  .

4-1. Remove the two screws that fix the PC terminal cover to the bottom cabinet.
4-2. Remove the two screws off the output shield.  Take out the output shield and disconnect the R-LCD, G-LCD

and B-LCD connectors (RP, GP, and BP).

4-3. Remove the four screws off the output unit.  Disconnect the insulating barrier, the ground leads and the

connectors (FN, Q, LL, FF, LF, BL, RC and EA). Pull up and away the output unit and the signal/PC terminal/
video board unit.

4-4. Peel off the shield sheet. Remove the four screws off the video board unit. Pull the unit toward yourself to

take it out.

4-5. Remove the two screws off the back of the output unit.  Separate this unit from the signal/PC terminal unit.
4-6. Remove the screw off the bottom cabinet and the screw off the power panel.  Now take out the power panel.

4-1

4-1

4-3

4-3

4-2

4-5

4-4

4-6

4-6

5-1. Remove the two screws off the angles A and B of the carrying handle.  Detach the carrying handle.
5-2. Remove the two screws off the lamp socket holder.  Take out the lamp socket.
5-3. Disconnect the bimetal connector (BA).  Remove the four screws off the optics mechanism assembly, and

pull up and away this assembly.

5-4. Remove the two screws off the exhaust panel. Separate the panel from the bottom cabinet.
5-5. Remove the screw off the power/ballast unit assembly.  Pull up and away the unit.

5-1

5-5

5-1

5-3

5-3

5-2

5-3

(BA)

5-3

5-4

B-LCD

G-LCD

GREEN

BLUE

BLUE

RED

R-LCD

Polarizer film

Dichroic coating
(B transmission)

Dichroic coating
(B reflection)

Incident polarizer plate R

Dichroic coating
(R transmission)

AL-coated mirror R

AL-deposited face 

Polarizer film

Marking

AR-coated face

Marking

G reflector

Dichroic coating

B/G reflector

AL-coated mirror W

AL-deposited
face

Fly-eye lens (incoming light)

UV cut filter

Metal-halide lamp
(Light source)

Relay lens 1

AL-deposited face

AL-coated mirror B

Projection Lens

 B reflector

Cross dichroic prism

Incident polarizer plate B

Relay lens 3

Relay lens 2

Incident polarizer plate G

Condenser lens G

Fly-eye lens (outgoing light) 

Condenser lens R

* The M3 mirrors have a coating

wedge (for different film thick-
ness).  Set up these mirrors, with
their markings positioned as
shown above, so that their
coated faces and both sides be
in the correct directions.