DOWNLOAD Sharp XG-MB70X Service Manual ↓ Size: 862.16 KB | Pages: 43 in PDF or view online for FREE

33

34

35

After replacing the DMD, if shading is present on the screen as shown in
Figure 1, adjust the lighting area of the DMD by turning the adjustment screws
for the optical engine.
1. Loosen the fixing screw for the adjustment lever 1. Adjust the lighting area
by adjustment lever 2 and then tighten the fixing screw for the adjustment
lever 1.
2. If the lightening area cannot be adjusted after the above procedure, loosen
the fixing screw 3, adjust the area with adjustment screws 4 and 5, and then
tighten the fixing screw 3.

36

Many electrical and mechanical parts in Projector have special safety-related characteristics.
These characteristics are often not evident from visual inspection, nor can protection afforded
by them be necessarily increased by using replacement components rated for higher voltage,
wattage, etc.
Replacement parts which have these special safety characteristics are identified in the

service manual; electrical components having such features are identified by 

 and

shaded areas in the Replacement Parts Lists and Schematic Diagrams. For continued
protection, replacement parts must be identical to those used in the original circuit. The use of
a substitute replacement parts which do not have the same safety characteristics as the
factory recommended replacement parts shown in the service manual, may create shock, fire
or other hazards.

The light source, metal halide lamp, in the projector emits small amounts of UV-
Radiation.
AVOID DIRECT EYE AND SKIN EXPOSURE.
To ensure safety please adhere to the following:
1. Be sure to wear UV protective glasses when servicing the projector
with the lamp turned “on” and the top enclosure removed.

2. Do not operate the lamp outside of the lamp housing.

3. Do not operate for more than 2 hours with the enclosure
removed.

UV-Radiation and Medium Pressure
Lamp Precautions
1. Be sure to disconnect the AC plug when replacing the lamp.
2. Allow one hour for the unit to cool down before servicing.
3. Replace only with same type lamp. Type AN-MB70LP rated 275W.
4. The lamp emits small amounts of UV-Radiation, avoid direct-eye contact.
5. The medium pressure lamp involves a risk of explosion. Be sure to follow installation
instructions described in the Lamp Replacement Procedure and handle the lamp with care.