Sharp MX-GBX1 Service Manual ▷ View online
5
2. INSTALLATION AND SET-UP OF SMARTPUNCH
2.1 RECOMMENDATIONS
AND PRE-REQUISITES
•
If installing the SmartPunch downstream from a Booklet Maker a SmartPunch cover kit is required.
2.2 UNPACKING
•
Inspect the outside of the package for shipping damage. If there is evidence of shipping damage,
contact the shipping carrier immediately.
contact the shipping carrier immediately.
•
Remove the punch from its shipping carton. It is recommended that three people remove the
punch unit from the carton; one lifting at the castors and two lifting at the top cover. DO NOT lift
using the front door panel.
punch unit from the carton; one lifting at the castors and two lifting at the top cover. DO NOT lift
using the front door panel.
•
Retain the smaller accessory box; it contains parts required for correct installation of the
SmartPunch.
SmartPunch.
•
Inspect for any concealed damage to the unit. If there is evidence of concealed shipping damage,
contact the shipping carrier immediately.
contact the shipping carrier immediately.
•
Remove all shipping tape from doors and levers.
2.3 SMARTPUNCH
INSTALLATIONS
(MX-M850) (MX-M950) (MX-M1100)
2.3.1 MX-FNX Finisher Preparation
Only the cables below are required to attach the SmartPunch to this type of finisher.
MX-FNX Finisher to SmartPunch Cable
Set up instructions for Sharp series Document number 771014AWA1
Only the cables below are required to attach the SmartPunch to this type of finisher.
MX-FNX Finisher to SmartPunch Cable
Set up instructions for Sharp series Document number 771014AWA1
P/N GBC7708935000
6
Plug the 7 Pin Communication Cable to CN114
on the MX-FNX finisher Board.
2.4 INSTALLING
THE
SOUND DEADENING FOAM
Supplied with the SmartPunch you will find six
strips of sound deadening foam shipped loose for
field installation. These are not attached at the
factory to avoid compression and/or damage
during shipping.
strips of sound deadening foam shipped loose for
field installation. These are not attached at the
factory to avoid compression and/or damage
during shipping.
To install, simply peal the back off to reveal the
adhesive using the following steps as a reference.
adhesive using the following steps as a reference.
7
2.4.1
Paper Exit Side (Finisher Side)
Apply the wide strip to the right side as
shown.
shown.
Apply one of the two shorter pieces to the
side of the top cover as shown.
side of the top cover as shown.
Apply one of the three longer strips to the left
rear panel as shown.
rear panel as shown.
Exit side complete
8
2.4.2 Paper Entrance Side (Multi-function / printer Side)
Apply one of the two remaining long strips to the
right side of the multi-function printer side of the
SmartPunch as shown.
right side of the multi-function printer side of the
SmartPunch as shown.
Apply the last remaining short strip to the top
cover edge of the multi-function printer side of the
SmartPunch as shown.
cover edge of the multi-function printer side of the
SmartPunch as shown.
Apply the last remaining long strip to the left side
of the multi-function printer side of the
SmartPunch as shown.
of the multi-function printer side of the
SmartPunch as shown.
Confirm that the copier and finisher have the latest firmware installed. For firmware support, visit
http://www.sharp-
indcservice.com
Click on the first or last page to see other MX-GBX1 service manuals if exist.