Sharp MX-FNX10 (serv.man38) Service Manual / Technical Bulletin ▷ View online
MX-FN10 How to check and correct phase deviation of the gripper
Confirmation of phase deviation
Confirmation of phase deviation
1. Remove the front lower cover. (1 screw)
2. Remove the front cover (with the inner cover). (5 screws)
Sharp Electronics (UK) Ltd., Technical Services Group
CCE-621
3. Open the staple replacement cover of the saddle stapler.
4. Turn the shaft clockwise with a flat screwdriver using the slit at the end of the square shaft of the upper gripper
unit to open the gripper.
5. Pull out the gripper unit.
Sharp Electronics (UK) Ltd., Technical Services Group
CCE-621
6. Confirmation of phase deviation of the gripper unit
As shown in the picture above, pull out the gripper unit until it touches the end of the bracket.
If phase deviation occurs, it is impossible to pull out to the position above, and it stops in the middle as in the
picture below.
If phase deviation occurs, it is impossible to pull out to the position above, and it stops in the middle as in the
picture below.
Sharp Electronics (UK) Ltd., Technical Services Group
CCE-621
7. Confirmation of phase deviation of the saddle stapler
Confirm if there is any phase deviation with the saddle stapler unit.
If the end of the saddle stapler touches the metal plate when the gripper unit is fully pulled out, it is normal.
There may be a small gap about 1mm because of looseness of the gear etc., but if it easily comes to the right
position by moving with your finger, there is no problem.
There may be a small gap about 1mm because of looseness of the gear etc., but if it easily comes to the right
position by moving with your finger, there is no problem.
Sharp Electronics (UK) Ltd., Technical Services Group
CCE-621
Click on the first or last page to see other MX-FNX10 (serv.man38) service manuals if exist.