Sharp MX-FN10 (serv.man4) Service Manual / Technical Bulletin ▷ View online
4. Mount the upper cover stay.
Rear side: Plate spring + screw
2/2
Mount the upper cover.
Front side: Screw (x1)
Close the upper cover.
Be sure not to forget to set the shaft
of actuator.
of actuator.
Replaced springs.
Hook the springs to the outer side than the springs at the opposite side that
are hooked on the same shaft.
are hooked on the same shaft.
Hook the upper hook to the shaft.
4. Mount the upper cover stay.
Rear side: Plate spring + screw
2/2
Mount the upper cover.
Front side: Screw (x1)
Close the upper cover.
Be sure not to forget to set the shaft
of actuator.
of actuator.
Replaced springs.
Hook the springs to the outer side than the springs at the opposite side that
are hooked on the same shaft.
are hooked on the same shaft.
Hook the upper hook to the shaft.
4. Mount the upper cover stay.
Rear side: Plate spring + screw
2/2
Mount the upper cover.
Front side: Screw (x1)
Close the upper cover.
Be sure not to forget to set the shaft
of actuator.
of actuator.
Replaced springs.
Hook the springs to the outer side than the springs at the opposite side that
are hooked on the same shaft.
are hooked on the same shaft.
Hook the upper hook to the shaft.
4. Mount the upper cover stay.
Rear side: Plate spring + screw
2/2
Mount the upper cover.
Front side: Screw (x1)
Close the upper cover.
Be sure not to forget to set the shaft
of actuator.
of actuator.
Replaced springs.
Hook the springs to the outer side than the springs at the opposite side that
are hooked on the same shaft.
are hooked on the same shaft.
Hook the upper hook to the shaft.
Display