Sharp MX-FN10 (serv.man3) Service Manual / Technical Bulletin ▷ View online
Sharp Electronics (UK) Ltd., Document Systems Support
C
1/1
Date:
26
th
April 2014
Model:
See below
Ref.:
ARE1123
Colour:
White
Page:
1 of 1
TECHNICAL BULLETIN
FIRMWARE UPGRADE
1. Model Name:
MX-FN10/FN11/FN17/FN18
2. Description:
Firmware upgrade for each model:
Model
Packing control No.
Version
Effective time
MX-FN10
B88
01.14.02.00
From April 2014 production
MX-FN11
A36
01.08.02.0a
From April 2014 production
MX-FN17
A29
02.01.03.00
From mid-April 2014 production
MX-FN18
(Finisher section)
(Finisher section)
A13
01.08.02.0a
From April 2014 production
Item of change:
1. When performing 2-Up print with the cover, Jam (FPDD_S etc.) may be caused depending on the
timing. This problem has been corrected. (MX-FN10)
2. When both sides are set to OFFSET on MX-M364N/M365N, the paper is curled, causing the jam.
Modification has been made to improve this issue. (MX-FN17)
3. Following has been implemented to improve the paper alignment:
When the interval between output papers gets wider while printing in duplex, the Finisher
discharges a batch of papers one by one accordingly instead of discharging the a batch and
output next batch at the same time.
(Note) For the support of No.3, PCU-
timing. This problem has been corrected. (MX-FN10)
2. When both sides are set to OFFSET on MX-M364N/M365N, the paper is curled, causing the jam.
Modification has been made to improve this issue. (MX-FN17)
3. Following has been implemented to improve the paper alignment:
When the interval between output papers gets wider while printing in duplex, the Finisher
discharges a batch of papers one by one accordingly instead of discharging the a batch and
output next batch at the same time.
(Note) For the support of No.3, PCU-
ROM needs to be updated to “03.00.o1.00” or later version.
Display
