DOWNLOAD Sharp MX-2600N / MX-3100N / MX-2600G / MX-3100G (serv.man108) Service Manual ↓ Size: 4.3 MB | Pages: 23 in PDF or view online for FREE

9. Secure the heater wire with a snap band. 

* Secure the heater wire with the snap band while pulling it in the arrow direction. (The lower part of the wire 

must be free from loose.) 

* Cut the snap band tip approx. 5 mm or less.  
 

 
10. Move the lamp UN by hand and check that all the movable parts move smoothly. 

* Check that there is no interference in the lower parts of the heater harness, wire, and 2/3 mirror UN. 
* Check that each part is free from interference. 
 

 
11. Remount the removed parts by reversing the procedure. 

 

Sharp Electronics (UK) Ltd., Technical Services Group

CCE-620 

Mounting the Desk Heater 
 
1) Put the heater (RHETP0131FCPZ, or RHETP0132FCPZ) in its mounting position of the heater mounting plate 

(LPLTM6089FCZZ). Fix the heater to the heater mounting plate with a piece of screw. 

2) Put the heater mounting plate (sub-ASSY) in its mounting position on the T-Heater cover. Fix the heater 

mounting plate (sub-ASSY) to the T-Heater cover with two pieces of screws. 

3) Fix the clamp. 
4) Attach the caution label (for high temperature), in its proper position along the alignment lines. 

* Degrease the surface where the label is attached to with alcohol-soaked cloth. 
 

 

Sharp Electronics (UK) Ltd., Technical Services Group

CCE-620 

5) Take out the first and second cassettes. 
 

 
6) Mount the heater (procedures (1) to (4)) and tighten screw (XHBS730P05000). 
 
7) Pass the harness through the rear frame and insert four snap bands. 
 

 
8) Remove the rear plate. (11 screws) 
 

 

Sharp Electronics (UK) Ltd., Technical Services Group

CCE-620 

9) Demount the AC cord mounting plate (120V series) and inlet mounting plate (230V series). (Two screws) 
 

 
10) Pass the body heater harness turned to the rear frame side in procedure (7) through the wire saddle. 
 
11) Bundle the heater harness and AC-DCWH harness with an Omega lock (LHLDW1334FCZZ). 
 
12) Connect the heater harness to the WH PWB UN. 
 

 
13) Mount the AC cord mounting plate (120V series) and inlet mounting plate (230V series). (Reversal of 

demounting in procedure (9)) 

* Engagement with wires must not occur during the plate mounting. 

 
14) Close the rear cabinet. (11 screws) (Reversal of removal in procedure (8)) 

 

Sharp Electronics (UK) Ltd., Technical Services Group

CCE-620