Sharp DX-C200P Service Manual ▷ View online
[4] Preventive maintenance
4-21
Clean the registration roller if prints are smeared after a paper jam is cleared.
8. Clean the registration roller by applying a soft damp cloth while turning it.
9. Using both hands, carefully push up the front cover until it closes.
9. Using both hands, carefully push up the front cover until it closes.
10. Plug in the power cord securely. Connect all the interface cables that were removed.
11. Turn on the power.
11. Turn on the power.
• When closing the front cover, push the upper area of the cover firmly.
Cleaning the Exposure Glass
The following procedure describes how to clean the exposure glass.
1. Lift the ADF.
Be careful not to hold the input tray when lifting the ADF, for the tray might be damaged.
2. Clean the parts indicated with arrows with a soft damp cloth and then wipe the same parts
with a dry cloth to remove any remaining moisture.
[4] Preventive maintenance
4-22
Cleaning the Auto Document Feeder
The following procedure describes how to clean the ADF.
1. Lift the ADF.
Be careful not to hold the input tray when lifting the ADF, for the tray might be damaged.
2. Clean the parts indicated with arrows with a soft damp cloth and then wipe the same parts
with a dry cloth to remove any remaining moisture.
Replacing the Fuser Unit
Make sure that the fusing unit is cool before you touch it. The fusing unit can be
very hot.
Make sure to restore the insulators, shields, etc after you service the fusing unit.
Fusing Unit
Execute "Reset Fuser Unit" with the "Engine Maintenance" menu if you replace
[4] Preventive maintenance
4-23
the fusing unit, otherwise a fusing error may occur.
1. Open the front cover.
2. Left cover.
3. Disconnect the connectors [A], [B].
[4] Preventive maintenance
4-24
4. Fusing unit [C] (
x 3)
It is likely to remove a fusing unit cover screw instead of the lower left fixing screw
by mistake. Make sure which screw should be removed before you do this step.
5. Execute "Reset Fuser Unit" with the "Engine Maintenance" menu if the fusing unit is
replaced.
Replacing the Middle transfer unit
Transfer Unit
If you install a complete new unit, execute "Reset 2nd Transfer Unit" with the
"Engine Maintenance" menu, otherwise a paper transfer error may occur.
"Engine Maintenance" menu, otherwise a paper transfer error may occur.
1. Open the front cover.
Click on the first or last page to see other DX-C200P service manuals if exist.