Sharp AR-S11 (serv.man4) User Manual / Operation Manual ▷ View online
5
USING THE 20-BIN SORTER
1
Place the original in the document feeder
tray (when a reversing automatic
document feeder is installed) or on the
document glass. (Refer to page 4-6 of
"Operation manual (for general
information and copier operation)".)
tray (when a reversing automatic
document feeder is installed) or on the
document glass. (Refer to page 4-6 of
"Operation manual (for general
information and copier operation)".)
2
Select copy settings as needed, including
two-sided or one-sided copy mode, paper
size select, exposure adjustment, and
copy ratio. (Refer to chapter 5 of
"Operation manual (for general
information and copier operation)".)
two-sided or one-sided copy mode, paper
size select, exposure adjustment, and
copy ratio. (Refer to chapter 5 of
"Operation manual (for general
information and copier operation)".)
3
Touch the [OUTPUT] key.
4
Touch the [SORTER] key.
5
Touch the key for the desired output
mode.
mode.
The touched key is
highlighted to indicate
that the function is
enabled.
highlighted to indicate
that the function is
enabled.
If the original was placed
on the document glass in
step 1, non-sort mode is
automatically selected. If
on the document glass in
step 1, non-sort mode is
automatically selected. If
the original was placed in the document feeder tray,
sort mode is automatically selected.
sort mode is automatically selected.
6
Touch the [OK] key.
7
Set the number of copies as needed and
press the [COLOUR COPY START (
press the [COLOUR COPY START (
)]
or [BLACK COPY START (
)] key.
Replace the original with
the next original and
press the [START] key.
Repeat this operation
until all originals have
been scanned.
the next original and
press the [START] key.
Repeat this operation
until all originals have
been scanned.
2-SIDED COPY
OUTPUT
READY TO COPY.
OUTPUT
SORT
GROUP
SORTER
OUTPUT
NON SORT
SORT
SORTER
GROUP
READY TO COPY.
OK
CENTRE TRAY
INTERRUPT
0
NOTES
●
●
●
●
● Maximum number of original pages
This is the maximum number of original pages that can be copied at once in sort mode or group mode.
In sort mode:
In sort mode:
The limit is the same as the maximum number of sheets that can be held in one bin. (See *1 in
the "SORTER CAPACITY" table on page 3.)
the "SORTER CAPACITY" table on page 3.)
In group mode: Up to 20 sheets (the same as the number of bins in the sorter).
●
●
●
● Maximum number of copies that can be set
The maximum number of copies that can be set in sort mode and group mode is as follows:
In sort mode:
In sort mode:
Up to 20 copies (the same as the number of bins in the sorter)
In group mode: The number of sheets that can be held in one bin (See *2 in the "SORTER CAPACITY" table on page 3.)
● When "Transparency film with insert sheets" or "A3 (11" x 17") Full-bleed" is selected (these are special
functions), the copies are output in non-sort mode. Sort and group modes cannot be selected.
● To cancel a copy run, press the [CLEAR] key. Copying will stop and the number in the copy quantity display will
be reset to 0.
AR_S11_03-06.fm 5 ページ ２００３年１月１３日 月曜日 午前９時５４分
6
MISFEED IN THE 20-BIN SORTER
When a misfeed has occurred during copying, the message "MISFEED HAS OCCURRED." will appear in the touch
panel display of the operation panel and copying output will stop.
panel display of the operation panel and copying output will stop.
1
Push the sorter release button and slide
the sorter carefully along the guides away
from the machine.
the sorter carefully along the guides away
from the machine.
2
Remove the misfed paper.
Remove the misfed
paper from the sorter.
paper from the sorter.
Remove the misfed
paper from the exit area
of the machine.
If you removed misfed
paper from the machine,
perform a "Reset after
misfeed in machine" as
explained at right before
proceeding to step 3.
paper from the exit area
of the machine.
If you removed misfed
paper from the machine,
perform a "Reset after
misfeed in machine" as
explained at right before
proceeding to step 3.
3
Slide the sorter back toward the machine
and latch it into place.
and latch it into place.
Confirm that the misfeed
display is cleared.
If the message
indicating a misfeed is
still displayed, check the
inside of the machine
and remove any
remaining misfed paper.
display is cleared.
If the message
indicating a misfeed is
still displayed, check the
inside of the machine
and remove any
remaining misfed paper.
NOTE
Touch the [INFORMATION] key for more detailed information as necessary.
Reset after misfeed in machine
If you removed misfed paper from the machine
in step 2, reset the machine as explained below.
If this is not done, it may not be possible to clear
the misfeed display.
in step 2, reset the machine as explained below.
If this is not done, it may not be possible to clear
the misfeed display.
1
Open the duplex bypass/inverter
unit.
unit.
Grasp the finger
hold and gently
open the unit.
hold and gently
open the unit.
2
Gently close the duplex bypass/
inverter unit.
inverter unit.
AR-S11_ex.book 6 ページ ２００２年１２月１７日 火曜日 午後７時４７分
7
FOR KEY OPERATORS
The following key operator programs can be used when the optional 20-bin sorter is installed.
To enter the key operator programs, see "Using the key operator programs" on page 3 of the Key Operator's Guide.
To enter the key operator programs, see "Using the key operator programs" on page 3 of the Key Operator's Guide.
■
■
■
■ Additional programs
All of the additional programs are enabled by touching the checkbox (
) to make a checkmark appear (
).
(See "Supplementary explanation of key operation for key operator programs" on page 4 of the Key operator's
guide.)
guide.)
DISABLING OF SORTER
This program is used to disable use of the 20-bin sorter when it malfunctions.
When disabled, copies cannot be output to the 20-bin sorter.
This program can be selected in the Device control category of general key operator programs. (See page 10 of
the Key operator's guide.)
When disabled, copies cannot be output to the 20-bin sorter.
This program can be selected in the Device control category of general key operator programs. (See page 10 of
the Key operator's guide.)
OVERRIDE SORTER BIN CAPACITY LIMIT
When the 20-bin sorter is installed and copying is performed in sort mode or group mode, copying normally stops
automatically if the capacity limit of each bin is reached.
This program allows you to override the capacity limit and allow copying to continue. Caution should be exercised
when enabling this program, as misfeeds, a machine failure, or copies overflowing from bins may result.
This program can be selected in the Copy settings (Other function settings) category of programs for copy mode.
(See page 14 of the Key operator's guide.)
automatically if the capacity limit of each bin is reached.
This program allows you to override the capacity limit and allow copying to continue. Caution should be exercised
when enabling this program, as misfeeds, a machine failure, or copies overflowing from bins may result.
This program can be selected in the Copy settings (Other function settings) category of programs for copy mode.
(See page 14 of the Key operator's guide.)
AR-S11_ex.book 7 ページ ２００２年１２月１７日 火曜日 午後７時４７分
Be sure to become thoroughly familiar with this manual to gain
the maximum benefit from the product.
the maximum benefit from the product.
Before installing this product, be sure to read the installation
requirements and cautions sections of the "Operation manual for
general information and copier operation".
requirements and cautions sections of the "Operation manual for
general information and copier operation".
Be sure to keep all operation manuals handy for reference
including this manual, the "Operation manual for general
information and copier operation" and operation manuals for any
optional equipment which has been installed.
including this manual, the "Operation manual for general
information and copier operation" and operation manuals for any
optional equipment which has been installed.
MODEL
AR-S11
Page
• MAIN FEATURES OF THE
AR-S11
• PART NAMES
• SPECIFICATIONS
• METHODS OF SORTING
COPIES
• SELECTING THE MODE OF
THE 20-BIN SORTER
• USING THE 20-BIN
SORTER
• MISFEED IN THE 20-BIN
SORTER
• FOR KEY OPERATORS
2
2
2
2
2
3
4
5
6
7
7
20-BIN SORTER
OPERATION MANUAL
AR-S11
PRINT IN CHINA
2003A
KS1
TINSE2447FCZZ
SHARP CORPORATION
Display
