Sharp AR-CF1 (serv.man2) Service Manual ▷ View online
CHAPTER 1 GENERAL DESCRIPTION
1-20
4)
Hold the empty staple case on its sides, and
slide it out.
slide it out.
Figure 1-311
5)
Set a new staple case.
Figure 1-312
6)
Pull the length of tape (used to hold the sta-
ples in place) straight out.
ples in place) straight out.
Figure 1-313
7)
Push in the stapler unit until the blue lever
returns to its original position.
returns to its original position.
Figure 1-314
8)
Check to make sure that the stapler has been
locked in place, and close the front cover.
locked in place, and close the front cover.
Figure 1-315
Reference:
You may set no more than one staple cartridge at
a time.
Make sure that the new cartridge is one
specifically designed for the finisher unit.
a time.
Make sure that the new cartridge is one
specifically designed for the finisher unit.
CHAPTER 1 GENERAL DESCRIPTION
1-21
C.
Removing Staple Jams
from the Finisher Unit
from the Finisher Unit
If the host machine indicates the finisher unit
staple jam message, perform the following to
remove the jam.
1)
remove the jam.
1)
Remove the stack waiting to be stapled from
the delivery tray.
the delivery tray.
Figure 1-316
2)
Open the front cover.
Figure 1-317
3)
Shift down the blue lever.
Figure 1-318
4)
When the staple cartridge has slightly slid
out, hold and pull it out.
out, hold and pull it out.
Figure 1-319
5)
Shift down the tab on the staple cartridge.
Figure 1-320
6)
Remove all staples that have slid out of the
staple case.
staple case.
Figure 1-321
CHAPTER 1 GENERAL DESCRIPTION
1-22
7)
Return the tab on the staple cartridge to its
original position.
original position.
8)
Return the staple cartridge to its original
position, and close the front cover.
position, and close the front cover.
Figure 1-322
D.
Removing Paper Jams
from the Saddle Stitch
Unit (Saddle Finisher)
from the Saddle Stitch
Unit (Saddle Finisher)
If the host machine indicates the saddle stitch
unit paper jam message, perform the following to
remove the jam.
remove the jam.
1)
Holding the saddle stitch unit as shown,
move it to detach it from the host machine.
move it to detach it from the host machine.
Figure 1-323
2)
Open the front lower cover.
Figure 1-324
Reference
When the cover has been closed, the stapler unit
will automatically execute idle punching several
times to advance the staples.
will automatically execute idle punching several
times to advance the staples.
CHAPTER 1 GENERAL DESCRIPTION
1-23
3)
Turn the knob on the left side.
Figure 1-325
4)
Turn the knob on the right side while pushing
it in.
it in.
Figure 1-326
5)
Remove the jam.
Figure 1-327
6)
Open the inlet cover, and remove the jam.
Figure 1-328
7)
Close the front lower cover.
Figure 1-329
8)
Connect the finisher unit.
9)
Operate as instructed on the display.
Click on the first or last page to see other AR-CF1 (serv.man2) service manuals if exist.