Sharp AR-810 (serv.man13) Service Manual ▷ View online
AR-651/810 PAPER FEEDING SECTION 9 - 21
[F] Feed drive unit
(1) Remove the power supply unit.
(2) Remove 3 screws and take off the power cable
connecting section.
(3) Remove 6 screws and take off the feed drive
unit.
AR-651/810 PAPER FEEDING SECTION 9 - 22
[G] Tandem LCF
(G-1) Feed side front guide
(1) Remove 2 screws fixing the feed side front guide.
(2) Lift the paper guide a little and insert it in the
groove of the paper size marking. Then tighten
up the screw after confirming the screw hole
position.
(G-2) Feed side rear guide
(1) Remove 2 screws fixing the feed side rear guide.
(2) Lift the paper guide a little and insert it in the
groove of the paper size marking. Then tighten
up the screw after confirming the screw hole
position.
Paper size marking
A4
LT
LT
A4
Paper size marking
AR-651/810 PAPER FEEDING SECTION 9 - 23
(G-3) Standby side front guide
(1) Remove 1 screw fixing the standby side front
guide and move the guide toward the
direction of the white arrow.
(2) Lift the paper guide a little and insert it in the
groove of the paper size marking. Then tighten
up the screw after confirming the screw hole
position.
(G-4) Standby side rear guide
(1) Remove 1 screw fixing the standby side rear
guide and move the guide toward the direction
of the white arrow.
(2) Lift the paper guide a little and insert it in the
groove of the paper size marking. Then tighten
up the screw after confirming the screw hole
position.
A4
LT
LT
A4
AR-651/810 PAPER FEEDING SECTION 9 - 24
(G-5) Standby side paper mis-stacking detection
sensor
(1) Remove 2 screws and release the sensor
bracket.
(2) Disconnect 1 connector.
(3) Release the latches and take off the sensor.
(G-6) End fence home position sensor/Standby side
empty sensor
(1) Disconnect 1 connector and release the harness
from the clamp.
(2) Remove 1 screw fixing the standby side rear
guide. Then move the guide toward the direction
of the white arrow and take it off.
(3) Remove 1 screw and release the bracket.
(4) Disconnect the connector.
(5) Release the latches from the back side of the
tandem LCF cassette, and take off the end fence
home position sensor and standby side empty
sensor.
Latch
Connector
End fence home position sensor
Standby side empty sensor
Clamp
Click on the first or last page to see other AR-810 (serv.man13) service manuals if exist.