Sharp RZ-X735 (serv.man3) Service Manual ▷ View online
27
Obtain mount which meets VESA 75/100 standards and can support weight of
the POS Terminal.
the POS Terminal.
1
Install the new mount according to manufacturer requirements and recomendations.
2
Remove the POS terminal stand.
3
1
2
Use screws from stand to attach POS Terminal to VESA mount plate.
4
Assembly the VESA mount stand
To assemble the VESA mount stand, follow these steps :
To assemble the VESA mount stand, follow these steps :
28
1
2
Disassembly of the system
Make sure the system and peripherals are off.
1
Remove screws from the stand.
3
Disconnect cables for the peripherals and DC power input jack from the system.
2
1
2
5
4
Remove the SSD plastic cover and take out the solid state disk.
4
SYSTEM DISASSEMBLY & COMPONENT
REPLACEMENT
Note:
•
If ‘customer display (CDP)’ is installed,
remove it as written in the ‘customer display
attachment’ customer display (CDP) is
optional. If it is not assembled, move to the
next step.
remove it as written in the ‘customer display
attachment’ customer display (CDP) is
optional. If it is not assembled, move to the
next step.
3
29
Remove screws of the back plastic cover and remove the back plastic cover.
2
Remove screws at the back of the MSR (Magnetic Stripe Reader) rear cover.
The MSR rear cover should be opened towards the direction of the arrow.
The MSR rear cover should be opened towards the direction of the arrow.
1
1
2
Remove screws of the back metal cover and remove the back metal cover.
3
1
2
1
3
5
2
4
MSR removal (for EU only)
30
IO port removal
Remove screws of the IO port, disconnect all the cables and remove the IO port.
Inverter board removal
Remove screws of the inverter board, disconnect cables
and disassembly the inverter board.
and disassembly the inverter board.
1
2
3
Pull out the power and data cables of SSD from the mainboard.
4
1
2
3
Click on the first or last page to see other RZ-X735 (serv.man3) service manuals if exist.