Sharp SD-SH111 (serv.man10) Service Manual ▷ View online
– 29 –
SD-SH111
DESCRIPTION OF AND HOW TO AVOID ERROR AND ABNORMALITY INDI-
CATIONS
CATIONS
Error
Cause
Preventive measure
NO DISC
• A disc is not loaded.
• The disc cannot be recognized due to scratches
• The disc cannot be recognized due to scratches
or dirt.
• The disc is loaded upside down.
Press the Open/Close key to open the cover and load a disc.
Clean the disc.
Load the disc in a proper direction.
Clean the disc.
Load the disc in a proper direction.
NO PLAY
• Unplayable disc
• The disc cannot be played correctly due to
• The disc cannot be played correctly due to
scratches or dirt.
• The disc does not satisfy the standards.
Load a playable disc.
Clean the disc.
Clean the disc.
READ err
• Unplayable disc
• Data cannot be read since the disc is scratched
• Data cannot be read since the disc is scratched
or dirty.
• The disc does not satisfy the standards.
Load a playable disc.
Clean the disc.
Clean the disc.
Er-CD01
• The pick position detection switch of CD/DVD
mechanism does not work (defective
mechanism).
mechanism).
Set the unit to the stand-by mode and turn it on again.
Er-CD30
• The DVD unit and microcomputer do not
communicate properly.
• The DVD unit is defective.
• The unit is used where external noise is picked
• The unit is used where external noise is picked
up.
• The power supply picks up noise.
• Move the unit away from the noise source if located near.
• Use another AC outlet.
• Set the unit to the stand-by mode and turn it on again.
• Use another AC outlet.
• Set the unit to the stand-by mode and turn it on again.
DSP NG
DSP malfunction
• The unit is used where external noise is picked
• The unit is used where external noise is picked
up.
• The power supply picks up noise.
• Move the unit away from the noise source if located near.
• Use another AC outlet.
• Set the unit to the stand-by mode and turn it on again.
• Use another AC outlet.
• Set the unit to the stand-by mode and turn it on again.
No Signal
• Signals are not sent to the external digital input
socket (optical).
• Signals input to the external digital input socket
(optical) have unplayable formats.
Check the connection and signals at the external digital input
socket (optical).
socket (optical).
TEMP
• The temperature of the power supply is too
high.
Before use, set the unit to the stand-by mode and wait for a
while.
while.
Er-AP02
Er-AP03
Amplifier is defective
(A/D reset monitor detects an error.)
(A/D reset monitor detects an error.)
Set the unit to the stand-by mode and turn it on again.
Er-AP14
ICs of A/D and D/A converters cannot
communicate properly.
communicate properly.
• Move the unit away from the noise source if located near.
• Use another AC outlet.
• Set the unit to the stand-by mode and turn it on again.
• Use another AC outlet.
• Set the unit to the stand-by mode and turn it on again.
Amplifier is defective
Set the unit to the stand-by mode and turn it on again.
Display
