DOWNLOAD Sharp AY-X08 (serv.man13) Service Manual ↓ Size: 341.68 KB | Pages: 7 in PDF or view online for FREE

37

1. Push the center of display cover from the back.
2. Slide the display cover to the right.

1. Slide the left end of the display cover through 3 hooks

on the front panel along the guide from the center of
the front panel.

2. After the left half is inseted completely, press the

display cover and snap in the 3 hooks on the right.

2. Remove the screw fixing the terminal board.

1

2

1. Remove the photo detector unit.

(Press and spread the upper hook, and the photo
detector unit will be ready for removal.)

3. Remove a screw fixing the cord holder.

4. Remove 2 screws fixing the board (transformer).

5. Pull the board.

38

1. Remove 3 screws fixing motors.

2. Turn the cap area of the drain hose counterclockwise,

and remove it from the drain pan.
During installation, turn the drain hose to the state of
the “engagement position”.
After reinstallation, verify that it is securely fastened.

How to remove the horizontal louver
Slightly pull down the hinge area, defelect thge louver,
and unhook it from the hinge. Remove the shaft from
each of the left and right sides.

Drain pan

Drain Hose

Groove

Projection

To disconned

To reconnect

39

1. Loose a screw fixing the side cover.

2. Loose the unit to unit cord.

3. Loose a screw fixing the cord clamp.

4. Loose 4 screws fixing the top panel.

5. Loose 6 screws fixing the front panel.

6. Cut 4 nylon bands.

7. Disconnect following connectors and each wire.

 Choke coil(two terminal)
 Fan motor
 Thermistor
 Reverse valve (AE-X08CR/10CR/13CR)

40

8. Remove the terminal cover of compressor.

9. Remove 3 terminals of compressor..

10. Loose 4 screws fixing the control box.

11. Take out the control box.

1. Loose the fan nut and fan can take out.

2. Fan motor is secured by 4 screws.