Panasonic TH-50PB2E / TH-65PB2E Service Manual / Other ▷ View online
Service Mode
Select each Mode by Up/Down button on the remote control.
• To enter IIC / NW / SD Mode press the “Action” button.
• To enter CD / MS / I Mode press the “Action” button.
• To enter IIC / NW / SD Mode press the “Action” button.
• To enter CD / MS / I Mode press the “Action” button.
To return to the CAT Panel, press the “R” button.
2 ways to enter the Service Mode
(1) Main unit + remote control operation
(1) Main unit + remote control operation
Press and hold the VOL (-) button on the unit
and press the RECALL button on the remote control 3 times quickly within 2 second.
and press the RECALL button on the remote control 3 times quickly within 2 second.
(2) Remote control operation only
1. Set the OFF timer except for [0] minute by OFF TIMER button.(30 minutes, 60minutes, 90 minutes)
2. Set the volume level of sound to 0 by VOL (-) button.
3. Press the RECALL button more than 3 seconds.
2. Set the volume level of sound to 0 by VOL (-) button.
3. Press the RECALL button more than 3 seconds.
How to access the Service Mode
“CAT Panel” is displayed.
IIC mode can display the test pattern or adjust the detailed parameter of the picture.
Select the subject as below by “Up/Down” buttons on the remote control.
Select the item by “Left/Right” buttons, and adjust optimum setting by “Volume Up/Down” buttons basically.
To exit the IIC MODE, press the “R” button.
Select the subject as below by “Up/Down” buttons on the remote control.
Select the item by “Left/Right” buttons, and adjust optimum setting by “Volume Up/Down” buttons basically.
To exit the IIC MODE, press the “R” button.
(1) Aging
(2) VSUS
(3) Pos/Size
(4) Chroma Control
(5) PANEL W/B Adj
(6) Mirror
(7) RGB Sub Adjust
Test pattern is changed
each time the “Enter”
button is pressed.
each time the “Enter”
button is pressed.
When plasma panel or A-board is
replaced, VSUS setting is required.
If there are some abnormality of the
panel in the “LOW” setting, set the
“HIGH”.
but if remaining abnormality, the
panel is defective.
replaced, VSUS setting is required.
If there are some abnormality of the
panel in the “LOW” setting, set the
“HIGH”.
but if remaining abnormality, the
panel is defective.
Picture can be reversed to left and right or up and down by “Volume
Up/Down” buttons.
Check the abnormal area on the screen.
Up/Down” buttons.
Check the abnormal area on the screen.
IIC MODE
Aging
VSUS
Mirror
Set-MCU Version
LAN-MCU Version
WIRED
: Wired LAN MAC address
on the A-board.
WIRELESS : MAC address of
the Wireless Module.
SOS History
Displayed in hex number.
Displayed in hex number.
SERIAL No.
By the set for which A-board was
exchanged, a serial number is displayed
as bar [-----].
In this case, look at the original serial No.
on the rear cover.
By the set for which A-board was
exchanged, a serial number is displayed
as bar [-----].
In this case, look at the original serial No.
on the rear cover.
CD mode can check the firmware version, MAC address and SOS history etc.
To exit the CD mode, press the “R” button.
To exit the CD mode, press the “R” button.
CD MODE
Click on the first or last page to see other TH-50PB2E / TH-65PB2E service manuals if exist.