Panasonic TC-15DT2 Service Manual ▷ View online
3. Insert the pickup FPC into connector FP5201 on the
module P.C.B.
4. Remove the solder from the pickup FPC´s soldered short-
circuit.
5. Adjust the optical pickup tilt after removing the solder.
(Refer to section 11.12, Optical Pickup Tilt Adjustment.)
8.11. Disassembling the Spindle
Motor Unit
1. Remove the three screws.
Note
Be sure to adjust the optical pickup tilt after replacing
the spindle motor unit.
the spindle motor unit.
25
TC-15DT2
8.12. Disassembling the
Intermediate Chassis
1. Push the stopper downward, then rotate it until it contacts
the Vertical cam.
2. Release the 2 tabs.
8.13. Disassembling the Vertical
cam and Drive gear
1. Rotate the Vertical cam until it reaches the contact position.
2. Lift the Vertical cam straight upward to pull it out.
3. Remove the Drive gear.
8.14. Disassembling the Pulley Gear
and Deceleration Gear
1. Remove the screw.
2. Remove the pulley gear.
3. Remove the belt.
4. Remove the deceleration gear.
8.15. Disassembling the Mechanism
Loading P.C.B.
1. Remove the 2 screws.
2. Remove the 2 screws.
3. Release the three tabs.
26
TC-15DT2
8.16. Optical Pickup Tilt Adjustment
27
TC-15DT2
Notes
•
•
•
• Adjustment is generally unnecessary after replacing other parts of the traverse unit. However, adjust if there is a noticeable
degradation in picture quality.
•
•
•
• Optical adjutments cannnot be made inside the optical pickup.
•
•
•
• Adjustment is generally unnecessary after replacing the traverse unit.
28
TC-15DT2
Click on the first or last page to see other TC-15DT2 service manuals if exist.